PREDICTIONS OF KAON AND PROTON PRODUCTIONS IN PP COLLISIONS AT 7 TeV KRISTIYA TOMUANG Department of...

Preview:

Citation preview

1

PREDICTIONS OF KAON AND PROTON PRODUCTIONS IN PP COLLISIONS AT 7 TeV

KRISTIYA TOMUANG

Department of Physics, Naresuan University

Topics

Introduction Model and Calculation Research Methods Result & Conclusion

2

Introduction

3

Exotic nuclei is using as a key topics in nuclear and astronomy physics to understand the structure of matter, interaction and fundamental force including evolution of the universe.

Introduction

Exotic Nuclei

Exotic Nuclei -an exotic atom is an otherwise normal atom in which one or more sub-atomic particles have been replaced by other particles of the same charge.

Muon Pion Kaon

4

Introduction

Kaonic Nuclei

Kaonic Nuclei-an exotic atom consisting of negative charge of kaon orbiting two proton.

kaonic nuclei molecule, results from a fusion of and p, namely, as a boundstate of

Λ∗

Λ∗

𝐾 −𝑝

5Toshimitsu Yamazaki and Yoshinori AkaishiPhys. Rev. C 76, 045201 (2007)

Model and Calculation

PACIAE models has been developed from the PYTHIA model. PACIAE is a model not only for elementary collisions, but also for nucleus-nucleus collisions.

The PACIAE model consists of four stages

parton initialization parton evolution (rescattering) Hadronization Hadron evolution (rescattering)

PACIAE models

7

8

Model and Calculation

Parton initialization

Nucleus-nucleus collision is decomposed into nucleon-nucleon (NN) collisions. The string fragmentation is switched-off and diquarks (anti-diquarks) are broken into quarks

9

Model and Calculation

Parton evolution (rescattering)

Parton evolution or called “parton rescattering” is the proceeded from parton initialization until partonic freez-out.

Model and Calculation

Hadronization

Hadronization is the process after parton rescattering. the string fragmentation was built up.

10

Model and Calculation

Hadron evolution (rescattering)

Hadron evolution is proceeded until hadronic freez-out such as 𝐾 ,𝑝 ,𝜋 ,𝑛 , Λ ,Σ , 𝐽 /Ψ

11

12

Model and Calculation

DCPC model is the model that used to construct the cluster of particles and calculate the yield of light nuclei (anti-nuclei) after the transport model simulations.

Dynamically constrained phase space coalescence model(DCPC model)

uncertainty principle ∆ �� Δ �� ≥h3

q is the position and p is the momentum of particle

(1)

Model and Calculation

We can estimate the yield of single particle by definition as following intregal

EH h

pdqdY

31

The yields of N cluster can be estimated as

EH NNN

N h

pdqdpdqdY

311 ...

...

(2)

(3)

13

14

Model and Calculation

Similarly for the yield of can estimated by

9

332211123...

h

pdqdpdqdpdqdYKpp

0

1

123

otherwusr

DqDqDq

mmmm

ppKif

inv

,,,

3,2,1

023013012

00

Where

2/12321

2321 pppEEEminv

is the rest mass of kaonic nuclei. refer to the allowed uncertainty. is the limiting the spatial position.

𝑚0

𝐷0

m

Invariant mass

(4)

(5)

Research Methods

Measure the charge particles , and yields and simulate the productions at scaled mid-rapidity < 0.5 from the simulation of proton and proton collisions at 7 TeV by using PACIAE+DCPC model

Analyze the result from PACIAE+DCPC model and compare the result with ALICE data.

𝐾 ±𝑝 𝑝

15

Result

yields ALICE data PACIAE model

K+ 0.286 0.289K- 0.286 0.285p 0124 0.182

0.123 0.172K-pp - 0.029K+ - 0.026

Proton -Proton collisions at 7 TeV |𝑦|≤0.5

16

18

Conclusion

Measurement of charge particles , and yields at scaled mid-rapidity < 0.5 in pp collsions at 7 TeV the simulation can be reasonably described by ALICE

The predictions of kaonic nuclei and productions can be consistent with the yields of , and by The value of kaonic nuclei productions are under the maximum number of proton (anti-proton) and kaon (anti-kaon)

𝐾 ±𝑝 𝑝

𝐾 ±𝑝 𝑝

19

THANK YOU