View
110
Download
2
Category
Tags:
Preview:
Citation preview
04/09/231
PIKASHOES-(or ghetto force lightning for Jedi dummies)
04/09/232
INTRODUCTION
Pikashoes is a working model in which shoes are used and it is inspired by POKEMONE (a small yellow rat capable of shooting lightning out of its ass).
04/09/233
Principle
It works on the principle of potential difference between two bodies. Body will charge up with a low enough current that you don't even feel it. If the negative terminal of the generator is in contact with the earth during this time, your body will build up a large voltage difference with respect to earth. When you touch someone who is uncharged, so charge will leap from you to him with a spark, and cause him to squeal with shock
04/09/234
Component Required
12v Negative ion generator
Crappy rubber soled shoes.
Aluminium foil
Plastic switch from old power supply
9-12v battery with optional clip
Duct tape
Glue
Dremel
04/09/235
Components are…
04/09/236
Working
If you connect the high voltage output of a certain negative ion generator to your body, your body will charge up with a low enough current that you don't even feel it. If the negative terminal of the generator is in contact with the earth during this time, your body will build up a large voltage difference with respect to earth. When you touch someone who is standing on the same ground as you, he is uncharged, so charge will leap from you to him with a spark, and cause him to squeal like that car salesman guy in True Lies after Arnold arnolded him. You could also touch your hand to anything else that is earthed, and it will spark (and hurt). The obvious thing to do is to mod this generator into a shoe, because it allows for easy contact to both the earth and your body.
04/09/237
Circuit Diagram
04/09/238
Procedure- how to make it
To make pikashoe we have to follow the following steps…….
04/09/239
Step 1
By cutting out space for the battery, generator and switch in shoe and also cut off the useless chunk of plastic on the generator with the help of dremel as shown in fig. a b
04/09/2310
Step 2
Set battery,generator and switch in cutted space as shown in the fig c
04/09/2311
Step 3
Strip the negative wire and solder on the switch. Glue some of the bits in place and make sure there's a nice area of foil touching the stripped -ve wire as shown in fig. d and fig. e respectively.
04/09/2312
Step 4
Duct tape over the battery and generator to protect/hold them in place. Then stick some more foil on to get a really nice ground plate as shown in fig f and g respectively
04/09/2313
Step 5
Poke the high voltage wire through the sole of the shoe, and strip it so it can be in contact with the bottom of your foot. Don't use Al foil for this part- it screws everything up as shown in fig h.
04/09/2314
Step 6
Ready to pawn
04/09/2315
Note :
For maximum pain, zap people with an insensitive part of your hand, like your knuckle, and touch the victim on a sensitive area like their fingertips, neck,etc.
04/09/2316
04/09/2317
Practical application
Act as a safety precaution for girls. Pranks can be played with friends.
04/09/2318
Submitted by: Mentors:
Meenakshi Soda Neha Singh
Noreena Shrimali Vishu
Krishna D Bhawani
Priti Singh
Recommended