04/09/231

PIKASHOES-(or ghetto force lightning for Jedi dummies)

04/09/232

INTRODUCTION

Pikashoes is a working model in which shoes are used and it is inspired by POKEMONE (a small yellow rat capable of shooting lightning out of its ass).

04/09/233

Principle

It works on the principle of potential difference between two bodies. Body will charge up with a low enough current that you don't even feel it. If the negative terminal of the generator is in contact with the earth during this time, your body will build up a large voltage difference with respect to earth. When you touch someone who is uncharged, so charge will leap from you to him with a spark, and cause him to squeal with shock

04/09/234

Component Required

12v Negative ion generator

Crappy rubber soled shoes.

Aluminium foil

Plastic switch from old power supply

9-12v battery with optional clip

Duct tape

Glue

Dremel

04/09/235

Components are…

04/09/236

Working

If you connect the high voltage output of a certain negative ion generator to your body, your body will charge up with a low enough current that you don't even feel it. If the negative terminal of the generator is in contact with the earth during this time, your body will build up a large voltage difference with respect to earth. When you touch someone who is standing on the same ground as you, he is uncharged, so charge will leap from you to him with a spark, and cause him to squeal like that car salesman guy in True Lies after Arnold arnolded him. You could also touch your hand to anything else that is earthed, and it will spark (and hurt). The obvious thing to do is to mod this generator into a shoe, because it allows for easy contact to both the earth and your body.

04/09/237

Circuit Diagram

04/09/238

Procedure- how to make it

To make pikashoe we have to follow the following steps…….

04/09/239

Step 1

By cutting out space for the battery, generator and switch in shoe and also cut off the useless chunk of plastic on the generator with the help of dremel as shown in fig. a b

04/09/2310

Step 2

Set battery,generator and switch in cutted space as shown in the fig c

04/09/2311

Step 3

Strip the negative wire and solder on the switch. Glue some of the bits in place and make sure there's a nice area of foil touching the stripped -ve wire as shown in fig. d and fig. e respectively.

04/09/2312

Step 4

Duct tape over the battery and generator to protect/hold them in place. Then stick some more foil on to get a really nice ground plate as shown in fig f and g respectively

04/09/2313

Step 5

Poke the high voltage wire through the sole of the shoe, and strip it so it can be in contact with the bottom of your foot. Don't use Al foil for this part- it screws everything up as shown in fig h.

04/09/2314

Step 6

Ready to pawn

04/09/2315

Note :

For maximum pain, zap people with an insensitive part of your hand, like your knuckle, and touch the victim on a sensitive area like their fingertips, neck,etc.

04/09/2316

04/09/2317

Practical application

Act as a safety precaution for girls. Pranks can be played with friends.

04/09/2318

Submitted by: Mentors:

Meenakshi Soda Neha Singh

Noreena Shrimali Vishu

Krishna D Bhawani

Priti Singh