View
67
Download
4
Category
Preview:
Citation preview
Crystal Structure 1
Lattice Sites in Cubic Unit Cell
Crystal Structure 2
Crystal Directions
Fig. Shows [111] direction
We choose one lattice point on the line as an origin, say the point O. Choice of origin is completely arbitrary, since every lattice point is identical.
Then we choose the lattice vector joining O to any point on the line, say point T. This vector can be written as;
R = n1 a + n2 b + n3c
To distinguish a lattice direction from a lattice point, the triple is enclosed in square brackets [ ...] is used.[n1n2n3]
[n1n2n3] is the smallest integer of the same relative ratios.
Crystal Structure 3
210
X = 1 , Y = ½ , Z = 0[1 ½ 0] [2 1 0]
X = ½ , Y = ½ , Z = 1[½ ½ 1] [1 1 2]
Examples
Crystal Structure 4
Negative directions
When we write the
direction [n1n2n3] depend on the origin, negative directions can be written as
R = n1 a + n2 b + n3c
Direction must be
smallest integers.
Y direction
(origin) O
- Y direction
X direction
- X direction
Z direction
- Z direction
][ 321 nnn
][ 321 nnn
Crystal Structure 5
X = -1 , Y = -1 , Z = 0 [110]
Examples of crystal directions
X = 1 , Y = 0 , Z = 0 [1 0 0]
Crystal Structure 6
Crystal Planes
Within a crystal lattice it is possible to identify sets of equally spaced parallel planes. These are called lattice planes.
In the figure density of lattice points on each plane of a set is the same and all lattice points are contained on each set of planes.
b
a
b
a
The set of planes in 2D lattice.
Crystal Structure 7
Miller Indices
Miller Indices are a symbolic vector representation for the orientation of an atomic plane in a crystal lattice and are defined as the reciprocals of the fractional intercepts which the plane makes with the crystallographic axes.
To determine Miller indices of a plane, take the following steps;
1) Determine the intercepts of the plane along each of the three crystallographic directions
2) Take the reciprocals of the intercepts
3) If fractions result, multiply each by the denominator of the smallest fraction
Crystal Structure 8
Axis X Y Z
Intercept points 1 ∞ ∞
Reciprocals 1/1 1/ ∞ 1/ ∞Smallest
Ratio 1 0 0
Miller İndices (100)
Example-1
(1,0,0)
Crystal Structure 9
Axis X Y Z
Intercept points 1 1 ∞
Reciprocals 1/1 1/ 1 1/ ∞Smallest
Ratio 1 1 0
Miller İndices (110)
Example-2
(1,0,0)
(0,1,0)
Crystal Structure 10
Axis X Y Z
Intercept points 1 1 1
Reciprocals 1/1 1/ 1 1/ 1Smallest
Ratio 1 1 1
Miller İndices (111)(1,0,0)
(0,1,0)
(0,0,1)
Example-3
Crystal Structure 11
Axis X Y Z
Intercept points 1/2 1 ∞
Reciprocals 1/(½) 1/ 1 1/ ∞Smallest
Ratio 2 1 0
Miller İndices (210)(1/2, 0, 0)
(0,1,0)
Example-4
Crystal Structure 12
Axis a b c
Intercept points 1 ∞ ½
Reciprocals 1/1 1/ ∞ 1/(½)
Smallest Ratio 1 0 2
Miller İndices (102)
Example-5
Crystal Structure 13
Miller Indices
Reciprocal numbers are:
2
1 ,
2
1 ,
3
1
Plane intercepts axes at cba 2 ,2 ,3
Indices of the plane (Miller): (2,3,3)
(100)
(200)(110)
(111) (100)
Indices of the direction: [2,3,3]a
3
2
2
bc
[2,3,3]
Crystal Structure 14
Crystal Structure 15
Indices of a Family or Form
Sometimes when the unit cell has rotational symmetry, several nonparallel planes may be equivalent by virtue of this symmetry, in which case it is convenient to lump all these planes in the same Miller Indices, but with curly brackets.
Thus indices {h,k,l} represent all the planes equivalent to the plane (hkl) through rotational symmetry.
)111(),111(),111(),111(),111(),111(),111(),111(}111{
)001(),100(),010(),001(),010(),100(}100{
Crystal Structure 16
There are only seven different shapes of unit cell which can be stacked together to completely fill all space (in 3 dimensions) without overlapping. This gives the seven crystal systems, in which all crystal structures can be classified.
Cubic Crystal System (SC, BCC,FCC) Hexagonal Crystal System (S) Triclinic Crystal System (S) Monoclinic Crystal System (S, Base-C) Orthorhombic Crystal System (S, Base-C, BC, FC) Tetragonal Crystal System (S, BC) Trigonal (Rhombohedral) Crystal System (S)
3D – 14 BRAVAIS LATTICES AND THE SEVEN CRYSTAL SYSTEM
TYPICAL CRYSTAL STRUCTURES
Crystal Structure 17
triclinic monoclinic
orthorhombic
tetragonal rhombohedral
hexagonal
cubic
Packing FractionPacking Fraction
In crystallography, atomic packing factor (APF) or packing fraction is the fraction of volume in a crystal structure that is occupied by atoms.
•Natoms is the number of atoms in the unit cell
•Vatom is the volume of an atom
•Vunit cell is the volume occupied by the unit cell
Unit Cell:
The smallest repeating unit in a three dimensionalstructure (lattice)
Characterized by a coordination number (number of nearest neighbors)
and a lattice parameter, a (edge length)
Bonding
Atomic radius -- Bulk density
Different geometric arrangements depending on the crystal type
Packing Fraction ofSimple cubic, Body centered, face centeredPacking Fraction ofSimple cubic, Body centered, face centered
Packing in Crystals
Simple Cubic Crystal
packing can be determined exactly
If these were atoms then there would be 8(1/8) atoms per cell or 1 atom per cell.
Packing Fraction of Simple Cubic Lattice
The packing fraction would be
(4/3)πr3/d3
r is related to d, r = d/2
Therefore, the packing is (4/3) π(d/2)3/d3 = 4π/24 =π /6 = 0.52
Simple Cubic (SC)Simple Cubic (SC)
• SC lattice and crystal structure
a
a = 2R
Where: R = atomic radius a = lattice parameter
a = 2R
Where: R = atomic radius a = lattice parameter
SC
Packing fraction = 54%
Coordination number = 6
Body Centered Cubic (BCC)
BCC
a = 4R
3Where: R = atomic radius a = lattice parameter
a
Packing fraction = 68%
Coordination number = 8
Where does this come from?
Cubic Packing - BCC
a
a
√2 a √2 a
a√3a
√3a=4R
a=4R/√3
Face Centered Cubic (FCC)
FCC
a = 2R 2
a = 4R
2
Where: R = atomic radius a = lattice parameter
A close-packed structure with a packing fraction of 74%
Coordination number = 12
Some Observations
Since a crystal structure is a lattice + basis the packing fraction of the simple cubic lattice can go beyond one atom bases.
However, some crystal structures that appear simple cubic are in fact not: The sodium chloride structure is actually face centered cubic with a basis of two atoms.
Crystal structure, in itself, is a course.
Calculating packing fraction for body centeredCalculating packing fraction for body centered
Body-centered cubic crystal structureBody-centered cubic crystal structure
Simple cubic: 0.52 Body-centered cubic: 0.68 Hexagonal close-packed: 0.74 Face-centered cubic: 0.74 Diamond cubic: 0.34
Recommended