How to put the X431 Eurotab 2 into online flash mode

How to put the X431 Eurotab 2 into online flash mode

The Launch X431 Eurotab 2 can re-flash control modules on some supported manufacturers; this

advanced online flash mode is deactivated as standard. To activate the online flash mode follow the below

instructions:

Launch Tech UK

Huxley Close, Newnham Industrial Estate,

Plymouth, Devon, PL7 4JN

Tel: 01752 344 989 Email: enquiries@launchtech.co.uk

From the main

screen select

‘Other Modules’

Select ‘Files’

Select ‘Local’

Select ‘CNLAUNCH’

Launch Tech UK

Huxley Close, Newnham Industrial Estate,

Plymouth, Devon, PL7 4JN

Tel: 01752 344 989 Email: enquiries@launchtech.co.uk

Select ‘X431

EUROTABII’

Select ‘assets’

Launch Tech UK

Huxley Close, Newnham Industrial Estate,

Plymouth, Devon, PL7 4JN

Tel: 01752 344 989 Email: enquiries@launchtech.co.uk

Scroll down

and find

‘StdCfg.ini’

Open ‘StdCfg.ini’

with ‘ES Note Editor’

Launch Tech UK

Huxley Close, Newnham Industrial Estate,

Plymouth, Devon, PL7 4JN

Tel: 01752 344 989 Email: enquiries@launchtech.co.uk

After modifying the file exit the ‘ES File Editor’ and use the device as normal. Once within the manufacturer

software, where applicable the online flash function will be visible on the menu and control modules can be

re-flashed by following the on screen instructions.

As default the ‘OnlineFlash=0’

and ‘Flash=0’ so this mode is

deactivated. These values need

to be changed in order to

activate online flash mode.

1. Select ‘Edit’

2. Change ‘OnlineFlash=1’ and

‘Flash=1’ by using the keyboard.

3. Press ‘Save’ once you

modified the values.

Launch Tech UK

Huxley Close, Newnham Industrial Estate,

Plymouth, Devon, PL7 4JN

Tel: 01752 344 989 Email: enquiries@launchtech.co.uk