Upload
others
View
3
Download
0
Embed Size (px)
Citation preview
How to put the X431 Eurotab 2 into online flash mode
The Launch X431 Eurotab 2 can re-flash control modules on some supported manufacturers; this
advanced online flash mode is deactivated as standard. To activate the online flash mode follow the below
instructions:
Launch Tech UK
Huxley Close, Newnham Industrial Estate,
Plymouth, Devon, PL7 4JN
Tel: 01752 344 989 Email: [email protected]
From the main
screen select
‘Other Modules’
Select ‘Files’
Select ‘Local’
Select ‘CNLAUNCH’
Launch Tech UK
Huxley Close, Newnham Industrial Estate,
Plymouth, Devon, PL7 4JN
Tel: 01752 344 989 Email: [email protected]
Select ‘X431
EUROTABII’
Select ‘assets’
Launch Tech UK
Huxley Close, Newnham Industrial Estate,
Plymouth, Devon, PL7 4JN
Tel: 01752 344 989 Email: [email protected]
Scroll down
and find
‘StdCfg.ini’
Open ‘StdCfg.ini’
with ‘ES Note Editor’
Launch Tech UK
Huxley Close, Newnham Industrial Estate,
Plymouth, Devon, PL7 4JN
Tel: 01752 344 989 Email: [email protected]
After modifying the file exit the ‘ES File Editor’ and use the device as normal. Once within the manufacturer
software, where applicable the online flash function will be visible on the menu and control modules can be
re-flashed by following the on screen instructions.
As default the ‘OnlineFlash=0’
and ‘Flash=0’ so this mode is
deactivated. These values need
to be changed in order to
activate online flash mode.
1. Select ‘Edit’
2. Change ‘OnlineFlash=1’ and
‘Flash=1’ by using the keyboard.
3. Press ‘Save’ once you
modified the values.
Launch Tech UK
Huxley Close, Newnham Industrial Estate,
Plymouth, Devon, PL7 4JN
Tel: 01752 344 989 Email: [email protected]