View
345
Download
5
Category
Preview:
Citation preview
www.y5net.com.kh y5net.speedtest.net
BY NETWORK TEAM Page | 1
How to configure PPPoE client on MikroTik Router
1. Create PPPoE client
We assume that our WAN port is ether1.
- Plug your WAN cable into ether1
- Click on “PPP” on left menu
-
www.y5net.com.kh y5net.speedtest.net
BY NETWORK TEAM Page | 2
- Click on plus sign “+” then choose “PPPoE Client”
- In “General” tab, you will see “ Interface” then choose it as “ether1”
www.y5net.com.kh y5net.speedtest.net
BY NETWORK TEAM Page | 3
- Go to “Dial Out” tab and then fill in User and Password
- Click on “Apply” then you will see “Status: connected” on the bottom
www.y5net.com.kh y5net.speedtest.net
BY NETWORK TEAM Page | 4
2. Set DNS - On the left menu, click on “IP” and then choose “DNS”
- Fill in the DNS IP addresses as below picture
www.y5net.com.kh y5net.speedtest.net
BY NETWORK TEAM Page | 5
3. Create bridge and add port into bridge - On the left menu, click on “Bridge” then click on “+” sign to add new bridge
- Enter the bridge name then click “OK” to finish
- In “Ports” tab, click on “+” sign to add port into bridge
- Select interface that you want to add into bridge (Ex: ether2, ether3, ether4, waln1) then
choose bridge that we have created earlier and click OK to finish.
www.y5net.com.kh y5net.speedtest.net
BY NETWORK TEAM Page | 6
4. Add IP address for LAN - Click on “IP” then choose “Addresses”
www.y5net.com.kh y5net.speedtest.net
BY NETWORK TEAM Page | 7
- Click on “+” sign to add new IP address
- Fill in the IP address and then choose the bridge name that you have created earlier
5. Create DHCP Server - Click on “IP” then choose “DHCP Server”
- Click on “DHCP Setup”, then choose your bridge and click next until finish
www.y5net.com.kh y5net.speedtest.net
BY NETWORK TEAM Page | 8
www.y5net.com.kh y5net.speedtest.net
BY NETWORK TEAM Page | 9
6. NAT LAN network - Click on “IP” on the left menu, then choose “Firewall”
- In general tab, select “srcnat” and choose pppoe-out1 (PPPoE name that you have created
earlier) in “out interface”.
- In action tab, choose “masquerade” then click OK to finish.
www.y5net.com.kh y5net.speedtest.net
BY NETWORK TEAM Page | 10
Recommended