Harley-Davidson Street 750 S U P P L E M E N T A R Y M A ......Harley-Davidson Street 750 2014-for...

Remove the seats and the side covers.

www.healtech-electronics.com PAGE 1/3

Lift up the fuel tank.

Locate the ignition coil connector between the

cylinders.

S U P P L E M E N T A R Y M A N U A L

Harley-Davidson Street 750

2014-

for iQSE-1 + QSH-P1H

www.healtech-electronics.com PAGE 2/3

Connect the QSH connectors in-line with the ignition coil

connector.

S U P P L E M E N T A R Y M A N U A L

Harley-Davidson Street 750

2014-

for iQSE-1 + QSH-P1H

Connect the QSH black wire terminal to the chassis

ground.

Mount the QSE sensor.(Use the new bolt and washers supplied with

the unit. Make sure to place one washer above the sensor and one washer below the sensor.

tighten the screw by 5-6 Nm.

When tightened, do not try to rotate the sensor body.)

www.healtech-electronics.com PAGE 3/3

Typical position for theQuickShifter easy.

Secure the unit Properly.

S U P P L E M E N T A R Y M A N U A L

Harley-Davidson Street 750

2014-

for iQSE-1 + QSH-P1H