Disk & RAID

Disk & RAID

2012-10-05

The first HDD (1956)• IBM 305 RAMAC

• 4 MB

• 50x24” disks

• 1200 rpm

• 100 ms access

• 35k$/y rent

• Included computer & accounting software(tubes not transistors)

10 years later

3

1.6

met

ers

Transportation of HDD

1 inch disk drive!

• 2000 IBM MicroDrive:– 1.7” x 1.4” x 0.2” – 1 GB, 3600 RPM,

5 MB/s, 15 ms seek– Digital camera, PalmPC?

• 2006 MicroDrive– 8 GB, 50 MB/s!

The internal look of HDD (now)

Data access of HDD

Access Time = Seek Time + Rotational Delay + Transfer Time

Redundant Array of Inexpensive Disks (RAID): 1987-1993

• Randy Katz and David Patterson: “Use many PC disks to build better storage?”

• RAID I built on 1st SPARC, 28 disks• RAID II custom HW, 144 disks• Today, RAID ~$25B industry• RAID students join industry and academia,

started own companies (VMware, Panassas)

The RAID paper D. A. Patterson, G. Gibson, and R. H. Katz, "A case for redundant

arrays of inexpensive disks (RAID)," in SIGMOD'88 Proceedings of the 1988 ACM SIGMOD International Conference on Management of Data, 1988, vol. 17, no. 3, pp. 109-116.

One of the important publications in computer science. http://en.wikipedia.org/wiki/List_of_important_publications_in_computer_science

EMC, HP, IBM, NetApp… have produced so many RAID-related storage products.

Better Storage?• Capacity?• Performance?• Availability?• ……

RAID introduction• A RAID is a Redundant Array of Inexpensive Disks.– In industry, “I” is for “Independent”– The alternative is SLED, single large expensive disk

• Disks are small and cheap, so it’s easy to put lots of disks (10s to 100s) in one box for increased storage, performance, and availability.

• The RAID box with a RAID controller looks just like a SLED to the computer. Data plus some redundant information is Striped across the disks in some way.

• How that Striping is done is key to performance and reliability----Different RAID levels 0-5, 6…

RAID0• Level 0 is non-redundant disk array• Files are Striped across disks, no redundant info• High read throughput• Best write throughput (no redundant info to write)• Any disk failure results in data loss• Reliability worse than SLED

Stripe 0

Stripe 4

Stripe 3Stripe 1 Stripe 2

Stripe 8 Stripe 10 Stripe 11

Stripe 7Stripe 6Stripe 5

Stripe 9

data disks

RAID1• Mirrored Disks, data is written to two places • On failure, just use surviving disk• On read, choose fastest to read• Write performance is same as single drive, read

performance is 2x better• Expensive

data disks mirror copies

Stripe 0

Stripe 4

Stripe 3Stripe 1 Stripe 2

Stripe 8 Stripe 10 Stripe 11

Stripe 7Stripe 6Stripe 5

Stripe 9

Stripe 0

Stripe 4

Stripe 3Stripe 1 Stripe 2

Stripe 8 Stripe 10 Stripe 11

Stripe 7Stripe 6Stripe 5

Stripe 9

RAID4• Block-level parity with Stripes• A read accesses all the data disks• A write accesses all data disks plus the parity disk• Heavy load on the parity disk

data disksParity disk

Stripe 0 Stripe 3Stripe 1 Stripe 2 P0-3

Stripe 4

Stripe 8 Stripe 10 Stripe 11

Stripe 7Stripe 6Stripe 5

Stripe 9

P4-7

P8-11

RAID5• Block Interleaved Distributed Parity• Like parity scheme, but distribute the parity info over all

disks (as well as data over all disks)• Better read performance, large write performance

data and parity disks

Stripe 0 Stripe 3Stripe 1 Stripe 2 P0-3

Stripe 4

Stripe 8 P8-11 Stripe 10

P4-7Stripe 6Stripe 5

Stripe 9

Stripe 7

Stripe 11

RAID6• Level 5 with an extra parity• Can tolerate two failures• What are the odds of having two concurrent failures?• May outperform Level-5 on reads, slower on writes

data and parity disks

Stripe 0 Stripe 3Stripe 1 Stripe 2 P0-3

Stripe 4

Stripe 8 P8-11 Q8-11

P4-7Stripe 6Stripe 5

Stripe 9

Q4-7

Stripe 10

Q0-3

Stripe 7

Stripe 11

Comparison of RAIDsRAID Levels Capacity Storage

Efficiency Availability Ran. Read

Ran. Write

Seq. Read

Seq. Write

0 S * N 100% * **** **** **** ****

1 S * N/2 50% **** *** *** ** **

4 S * (N-1) (N-1) / N *** **** ** **** **

5 S * (N-1) (N-1) / N *** **** ** **** ***

6 S * (N-2) (N-2) / N **** **** * **** **

Note: S indicates the capacity of a single disk, N indicates the number of the disks in a RAID set.

RAID4/5/6 Reconstruction

Trend & Discussion…

• Disk replace Tape? • Flash replace Disk?• RAID is dead?

Backup slides

Backup slides

Backup

Backup slides

Backup slides

Backup slides