Upload
vovi-phap-danh
View
60
Download
3
Embed Size (px)
DESCRIPTION
Citation preview
Vietnam Training Agenda
Introduction to DataLink Plus and DataVision
Installation of DataLink Plus
Installation of DataVision
Installation of Vietnam Bitmaps
DataLink Plus
Configuration of Outstations and System Exercise 1 Retrieval of Data from Vision meter Exercise 2 Viewing of Data Exercise 3 Exporting of Data Exercise 4 Load Profile Viewer Exercise 5
DataVision
Creation of Maps Exercise 1 Charts and Chart Templates Exercise 2 Reports and Report Templates Exercise 3 Tariffs Exercise 4 Automatic production of Charts & Reports – Queues Exercise 5
Installation of DataLink and DataVision
1. DataLink Plus
Insert disk marked DataLink Plus into computer disk drive Select the ‘Start’ button followed by the Run option Type in the path A:\Install, select the OK button
Select the option Full Installation of Application, select the OK button
Enter the source disk drive as A:\, select the OK button Enter the destination disk drive as C:\, select the OK button
The DataLink Plus software will now be installed into the C:\ABB\CS directory.
2. DataVision
Insert disk marked DataVison – Disk 1 into computer disk drive
Select the ‘Start’ button followed by the Run option Type in the path A:\Setup, select the OK button
The following box will then appear
Enter Disk 2, select the OK button. The following box will then appear
Select the OK button. The following screen will then appear
Select the button pointed to by the arrow i.e. installation button
The software will then installed into the C:\ABB\DVISION directory
Note : - For the remaining disks follow the instructions on the screen i.e. enter relevant disk, select the OK button.
3. Installation of Bitmaps
Insert disk marked Vietnam Bitmaps into computer disk drive.
Using Windows Explorer or Windows File Manager copy all bitmaps from the floppy disk A:\ into the directory C:\ABB\D_VISION\BITMAPS.