Upload
piyajo
View
720
Download
4
Tags:
Embed Size (px)
Citation preview
PROJECT MATERIALS SELECTION
Group 19 NJT2C
PRODUCT ANALYSIS - What is the function of your product? - How do the components interact? - How is it made? - What should it cost? - What should it look like?
What is the function of your product? -using with 6 sockets
-can slide in and slide out-have switch-safety with fuse- a universal electrical outlet-installation with table- power less than 2000 W
HOW DO THE COMPONENTS INTERACT?
1.Puller 2.Outer tube 3.Switch and sockets 4.Holding plate 5.Hole
6. Pin7.Outer tube8. Fuse
How is it made?
What should it cost? -Less than 200 Bath
What should it look like?
- modern- meet the design specifications- It actually works
MATERIAL SELECTIONo - What are the performance requirements?o - Based on the material selection chart, what
materials can you use?o - What are their mechanical, electrical, and
thermal properties?o - How much do they cost?o - Can they be recycled?
WHAT ARE THE PERFORMANCE REQUIREMENTS?
Requirement properties
Must conduct electricity Electrical conductivity
Light and stiff Low density and high strenght
Cheap Cost per kg
Non oxidation Non-ferrous materials
BASED ON THE MATERIAL SELECTION CHART, WHAT MATERIALS CAN YOU USE?
Young` s Modulus - Density
Strength -Density
Streng - Toughness
Strength – Max.Service Temperature
Resistivity -Cost
WHAT ARE THEIR MECHANICAL, ELECTRICAL, AND THERMAL PROPERTIES?
Mechanical Properties
Density :1000-2000, kg /m3Young`s modulus : 2 – 10 GpaStrengh :50 – 80 Mpa
Thermal Properties
Temperature range : 0 – 200 Celcius
Electrical Properties
Resistance range :10^14 - 10^15 Ωm
HOW MUCH DO THEY COST?
CAN THEY BE RECYCLED?
MANUFACTURING PROCESS SELECTION
o - What processes are suitable to your chosen materials?
o - What is the process technical performance?o - What is the manufacturing cost?
WHAT PROCESSES ARE SUITABLE TO YOUR CHOSEN MATERIALS?
For Business
Model Product
WHAT IS THE PROCESS TECHNICAL PERFORMANCE?
-Have a required smoothness.-Have a required dimension.-Have a high rate of produce per hour.
WHAT IS THE MANUFACTURING COST?
We will produce 10,000 pieceestimated costMaterial cost about 50/pieceStartup cost (mould) depen on batch size about
5Running cost about 20
Manufacturing cost about 75 baht
MATERIAL SELECTION DECISION
Polymers
PVC (Polyvinyl Chloride)
Thank you