Coat it and Forget it.

PermaClean 100

Induron Coatings Inc.3333 Richard Arrington Jr. Blvd N

Birmingham, Alabama 35234-2303Phone: 205-324-9584 · 800-324-9584 · Fax: 205-320-5220

induron.com · Email: info@induron.com

TTEESSTT MMEETTHHOODD DDUURRAATTIIOONN RREESSUULLTT

Impact Resistance ASMT D-2794 7 days 80 inch-pounds

Recoat - 140°F, Elcometer ASTM D-4561 24 hours OK

Adhesion, X-Cut ASTM D-3359 7 days 5A

5% Salt Water @ 120°F Immersion 10,500 hours No Effect

120°F Water Immersion ASTM D-714 24,000 hours No Effect

120°F 25% NaOH ASTM D-714 24,000 hours No Effect

Salt Spray 5% NaCl ASTM B-117

Non-scribed 24,000 hours No Effect

Scribed 10,500 hours 6 Rating

PERFORMACE TESTING

COAT IT AND FORGET IT.

With Induron’s Ceramic Epoxieswe’re ready to “Put our moneywhere our mouth is” with anunprecedented 15 year warranty

for immersion service in watertanks.

How is this possible you ask? Becausewe have over 30 years of experience with

ceramic epoxies in water tanks, sanitary sewageand other immersion exposures with no documented

failures on substrates that have been abrasive blasted with grit.

All of our ceramic epoxies use the same proprietary technologythat’s coated literally thousands of miles of sanitary sewagepipe and hundreds of water tanks.

To offer this 15 year warranty we have to eliminate as manyvariables as possible that can affect the service life of thecoating system. Most of the variables can be eliminated byproper inspection of field surface preparation and painting.Some of the variables are:

� Peened surfaces

� Oils, greases, mud and other contaminants on the surface from fabrication, transportation and job site staging prior to coating

� Carbon deposits left from blasting with steel abrasive

� Prime coats becoming hardened and chalked due toextended exposure to UV

� Solvent entrapment caused by high film build, cold weather &/or poor ventilation

A field inspected project using Induron’s PPeerrmmaaCClleeaann 110000 provides these advantages:

� Verification of specified surface cleanliness and anchor profile

� Solvent free system eliminates VOC’s, HAP’s and the possibility of solvent entrapment

� Unrivaled film build minimizes the risk of holidays(pinholes) and improves edge protection with up to 50mils in a single coat.

� Absolute minimal undercutting - Where pinholes occur, the corrosion cell is limited and the surroundingsubstrate is protected.

� Coatings applied immediately after surface preparation

� No chance for intercoat delamination

� Can be returned to service in 72 hours.

� A-Rated for cathodic disbondment.

� Ultra-Low Permeability keeps water away from your substrate. PPeerrmmaaCClleeaann 110000 has a metric perm rating well under 1.0.

Induron ceramic epoxies have performed well over the last 30 years, that’s why we’re willing to warrant ourceramic epoxies for up to 15 years. We know from experience they’re going to last longer than that.

If you’re ready to put a coating system inside and out on your tank that will last so long we’ll have to remindyou that you specified it, give your local Induron representative a call.

INDURON PROTECTIVE COATINGS PERMACLEAN 100

PermaClean Application