How To configure a ZTE Router

Step 1) open your browser type 192.168.1.1

Step 2) Go to Advanced Setting Choice ATM PVC Configuration with VPI 0/ VCI 35. Service

Category UBR without PCR. Save and move to next step.

Step 3) Connection Type PPPoE, Encapsulation mode: LLC/SNAP-BRIDGING. Save and

move to next step.

Step 4) Network Address Translation Settings: Enable NAT and Firewall, also select enable

WAN Service do not select IGMP multicast. Save and move to next step.

Step 5) In PPP username and Password enter the username and password given by your ISP.

Only tick the bridge PPPoE frames between WAN and Local ports option. Leave the rest

unchecked. Save and move to next step.

Wireless Configuration of ZTE Router:

Step 1) Select Wireless option on the left side. Select Basic, Enable Wireless, In SCID put any

name of your choice, Select the country. Save and move to next step.

Step 2) Select Security Select the SSID what you named SSID in basic. Keep Network

Authentication WPA2-PSK, WPA Pre-Shared Key of your choice /meaning enter any

password of your choice for the devices to connect to your router. WPA Group Rekey

Interval as 0, WPA Encryption TKIP, WEP encryption should be left disabled. Save and

reboot your router in management.