7
Inflatable Screens and Movie Inflatable Screens and Movie Shows: Screen Operating Instructions V 21092011

Draft Instructions Outdoor Events Australia New Screen set up your new screen 2 oakey creek rear projection 5m

Embed Size (px)

Citation preview

Page 1: Draft Instructions Outdoor Events Australia New  Screen  set up your  new  screen  2   oakey creek  rear  projection 5m

Inflatable Screens and Movie Inflatable Screens and Movie

Shows: Screen Operating

Instructions

V 21092011

Page 2: Draft Instructions Outdoor Events Australia New  Screen  set up your  new  screen  2   oakey creek  rear  projection 5m

Setting Your New Screen Up Setting Your New Screen Up

Page 3: Draft Instructions Outdoor Events Australia New  Screen  set up your  new  screen  2   oakey creek  rear  projection 5m

Setting the Screen Up First Time

You will need to set up the screen, as it has been delivered in shipping form.

Once the ropes and screen face are attached, there is no need to do this again; it

will be rolled up with all the fittings still attached.

Page 4: Draft Instructions Outdoor Events Australia New  Screen  set up your  new  screen  2   oakey creek  rear  projection 5m

• The key parts of the screen are in two pieces –

the screen, and the blower.

•The screen must be assembled before the first

use.

1. Take the screen out and unroll it. Please note -

red earth on the screen will discolour it

quickly. If you have red soil , we strongly

recommend the screen always be handled on recommend the screen always be handled on

top of a protective tarpaulin etc. Your screen

measures some 6.5m x 5 m when it is up, so

you need a tarpaulin that is bigger than that.

2. Unroll the black screen and the screen face

(the screen face is the silver colour oblong ).

3. You should also find bungee cords (if not

already attached to the screen) and ropes.

(these may be in the box with the blower.)

Page 5: Draft Instructions Outdoor Events Australia New  Screen  set up your  new  screen  2   oakey creek  rear  projection 5m

5. Lay the black screen out so it is like a photo frame.

6. Lay the silver screen out in the middle of the photo

frame(like a picture).

7. Check that the holes in the screen face match the holes

in the screen. If not turn the screen face up the other

way, or flip from left to right, until you find the best fit.

(it doesn’t have to be exact.)

Page 6: Draft Instructions Outdoor Events Australia New  Screen  set up your  new  screen  2   oakey creek  rear  projection 5m

8. Push a part of the loop of the bungee 8. Push a part of the loop of the bungee

cords through the screen eye hole,

then put the plastic snap fastener at

the other end of the bungee cord

through the loop, so now the bungee

is attached to the screen.

9. Clip the plastic clip to the silver screen

face

Page 7: Draft Instructions Outdoor Events Australia New  Screen  set up your  new  screen  2   oakey creek  rear  projection 5m

10. Tie the ropes to the ‘D’ rings.

Note - the shorter ropes are attached to the BOTTOM of the screen.

Longer ropes are attached to the top. Tie rather than use the

carbines provided, as it is stronger. The bottom has the blower

sleeve and the zip air vents.

Add ropes t the middle D rings halfway up the screen if wind is an

issue. (Middle D rings may not be on smaller screens)

Zip closed all air vents, and then follow instructions to ‘get your Zip closed all air vents, and then follow instructions to ‘get your

screen up’