Upload
arbrux-limited
View
71
Download
2
Embed Size (px)
Citation preview
Aerator4- Step Quick Install Guide
Thank you for choosing Arbrux! Our products represent great quality at a great price!
We have worked hard to become the benchmark for our industry since 1979. We are excited to show you how easy our products are to install...
Here we go...
Step 1: Fasten
Turn Float upside down
Join Motor Mount to float with supplied fasteners.
NOTE: See intake screen quick install guide if intake screen was purchased before performing these steps.
Step 2: Turn UprightTurn float over
so it is upright. You are now ready to put it in the water.
Step 3: Mooring AeratorBring aerator to desired location, tie mooring
ropes to aerator float, and fasten ropes to shore or anchors.
Step 4: Connect Power1. ½ HP 120 or 240 Volt
Single Phase (120 volt model shown)
2. 240 Volt Single Phase Control Panel (electrician required)
(optional on 1 HP, Standard on 2 & 3 HP)
3. Three Phase Control Panel (electrician required)
2
1
3
You’re Done... Time to Enjoy the View!
Email your images to [email protected] and you could be featured on our site!