Upload
abdul-haseeb
View
162
Download
2
Embed Size (px)
Citation preview
ASSIGNMENT # 2SUBMISSION BY : M.HASEEBSUBMISSION TO : SIR IMRAN
RAZADISCIPLINE : AMM-1ACOURSE : TEXTILE-176
IDENTIFICATION AND TESTING OF TEXTILE
FIBERS
A number of methods are available for characterization of the structural, physical, and chemical properties of fibers. Various methods are used for fiber identification like microscopic methods, solubility, heating and burning method, density and staining etc. End-use property characterization methods often involve use of laboratory techniques which are adapted to simulate actual conditions of average wear on the textile or that can predict performance in end-use.
TYPES OF TEST
The Non technical Test• FEELING TEST• BURNING TEST
The Technical Test• MICROSCOPIC TEST• CHEMICAL TEST
TESTS FOR IDENTIFICATION
Handle/Feel Test
Visual Examination
Burning test
Twist on Drying
Floatation Test
Microscopic analysis
Chemical Analysis
THE NON-TECHNICAL TESTS
Feeling test
Burning test
FEELING TEST
The feeling test requires perception if it is to
be of any value.
Skilled perception is acquired only after handling many different fabrics over a period of time.
Limitations of this test become apparent when examining and comparing fabrics of different fiber content.
BURNING TESTTo recognize the composition of fabrics by the burning test ,the sample of fiber, yarn of fabric should be moved slowly towards a small flame and the reaction to heat carefully observed .One end of the sample should be put directly into flame to determine its burning rate and characteristics. The burning odour should be noted and the characteristics of the ash such as amount ,form, hardness and color should be examined.
IDENTIFICATION OF F IBRES THROUGH BURNING TEST
Cotton :• When ignited it burns with a steady flame and
smells like burning leaves. The ash lefties easily crumbled. Small samples of burning cotton can be blown out as you would a candle.
Linen:• Linen takes longer to ignite. The fabric
closest to the ash is very brittle. Linen is easily extinguished by blowing on it as you would a candle.
Cotton Fiber Linen Fiber
Silk:• It is a protein fiber and usually burns readily, not
necessarily with a steady flame, and smells like burning hair. The ash is easily crumbled. Silk samples are not as easily extinguished as cotton or linen.
Wool • It is also a protein fiber but is harder to ignite than
silk as the individual "hair" fibers are shorter than silk and the weave of the fabrics is generally looser than with silk. The flame is steady but more difficult to keep burning. The smell of burning wool is like burning hair.
Silk Fiber Wool Fiber
MAN MADE FIBERS
Acetate:• Acetate burns readily with a flickering flame
that cannot be easily extinguished. The burning cellulose drips and leaves a hard ash. The smell is similar to burning wood chips.
Acrylic:• Acrylics burn readily due to the fiber content
and the lofty, air filled pockets. A match dropped on an acrylic blanket can ignite the fabric which will burn rapidly unless extinguished. The ash is hard. The smell is acrid or harsh
Acrylic FiberAcetate Fiber
Nylon: • Nylon melts and then burns rapidly if the
flame remains on the melted fiber. If i can keep the flame on the melting nylon, it smells like burning plastic.
Polyester:• Polyester melts and burns at the same
time, the melting, burning ash can bond quickly to any surface it drips on including skin. The smoke from polyester is black with a sweetish smell. The extinguished ash is hard.
Polyester Fiber Nylon Fiber
FIBER BURN CHART
LIMITATION OF BURNING TEST
It is apparent that many fibers have similar burning reactions that might cause doubt and occasional confusion.
TECHNICAL TESTSThere are certain technical tests performed for identifying various fibers. These tests require high technology laboratory equipment and are much more reliable than the non technical fiber tests.
Technical tests require high skilled personnel and technical know how of handling chemicals and their accurate analysis. These tests are very valuable for those fabrics that are a blend of different yarns and also have certain special properties including flame retardance etc.
TYPES OF TECHNICAL TEST
Microscopic test
Chemical test
MICROSCOPIC TESTMicroscopic test is a technical test that involves identifying the fabric with the help of a microscope with a magnification of minimum 100 power.
The test can easily distinguish between fibers.
The test identifies the natural fibers more easily as compared to man made ones.
Synthetic fibers are very similar in appearance and the increase in the number of varieties, makes it a little tough to distinguish the fibers even under a microscope
MICROSCOPIC TEST OF FIBERS
COTTON: • It is a single elongated cell. Under the microscope, it
resembles a collapsed, spirally twisted tube with a rough surface.
• The thin cell wall of the fiber has from 200 to 400convolutions per inch.
LINEN:• Under the microscope, the hair like flax fiber shows
several sided cylindrical filaments with fine pointed ends.
• The fiber somewhat resembles a straight, smooth.
Cotton Fiber Linen fiber
WOOL:• Under the microscope , wool’s cross
section shows three layers- epidermis, cortex and the medulla.
SILK:• It appears somewhat elliptical and
triangular in cross section when we see under the microscope.
• It is composed of fibroin, consisting of two filaments, called brin which is held together by sericin.
Silk fiber Wool fiber
ACETATE:• The cross sectional view has a
bulbous or multi global appearance with indentations.• These indentations appear as
occasional markings.
Acetate fiber
NYLON:• The basic microscopic appearance is generally
fine ,round, smooth, and translucent.• It is also produced in multilobal cross-sectional
types.
POLYESTERS: • Generally, polyester fibers are smooth and
straight and the cross-section is round.• This general characteristics may be altered to
achieve certain characteristics.
Nylon fiber
ACRYLICS: The methods of manufacturing of the acrylic fibers differ, the appearances vary accordingly.
ACRILAN ACRYLIC: It has a bean-shaped cross section, its longitudinal appearance is straight and smooth.
ORLON ACRYLIC: It has a flat, nut-shaped cross section.
CRESLAN ACRYLIC: It has an almost round cross section.
MOD ACRYLICS: it is of two types verel mod acrylic and SEF mod acrylic.
CHEMICAL TESTSChemical tests are another technical means of identifying fibers. But chemical tests are not intended for the general consumers.
Different types of chemical tests are under taken to establish the identity of the fibers used.
These tests give accurate and precise analysis.
The tests are conducted in research laboratories.
TYPES OF CHEMICAL TEST
Stain Test• Also known as the Double Barrel Fiber
Identification(DBFI), the test is based on the theory that each fiber has its own distinct two- color reaction when treated with stain. A fiber will turn to a particular color in the presence of dilute acetic acid and to some other specific color when stained in the presence of a mild alkali.
Solvent Test• The test involves treating the fibers in
certain solvents for identifying them. The technical test is becoming difficult to conduct as most of the manufactured fibers and their blends are chemically similar. There is no individual chemical or solvent test for separating or identifying the fibers in combinations.
Distinguishing animal from vegetable fibers with an acid :
• As strong alkali destroy animal substances, a 5%of soda lye solution in water can be used to eliminate wool and silk fibers from a sample that contains a mixture of fiber. The vegetable fibers will not be affected by this solution.
Distinguishing vegetable from animal fibers with an acid :
• As dilute acid destroy vegetable fibers, a 2%sulphuric acid solution can be used. A drop of solution is placed on the sample, which is then pressed with a hot iron. The spotted area will become charred if the sample is cotton linen or rayon.
DISTINGUISHING SILK FROM WOOL:• The use of concentrated cold hydrochloric acid
will dissolve the silk and the wool fiber swells.
DISTINGUISHING NYLON FROM OTHER FIBRES:
• If the fabric is thought to contain nylon, the fabric may be immersed in a boiling solution of sodium hydroxide. The nylon is insoluble in such a solution
DISTINGUISHING ACRYLICS FROM OTHER FIBRES:
• Acrylic fibers will dissolve in 70 percent solution of ammonium thiocyanate at 130 degree Celsius but the other fibers will not.
DISTINGUISHING LINEN FROM COTTON
~ Cotton and linen are immersed in a 1% solution of
fuchsine in alcohol to give red rose color. Later ,they are washed
and immersed into ammonia, linen retains the red coloration but
cotton does not.
Advantages:•More reliable than the non technical tests.•Used for both man made fibers and natural fibers.•Easily conducted.
Limitations •Certain manufacturing and finishing processes like mercerizing, affects the appearance of the fibers under the microscope.•Very dark colored fabrics cannot be identified under microscope.•Dye stuffs must be removed from fabrics.