Upload
media-designs
View
22
Download
2
Embed Size (px)
Citation preview
In the past few years, many professionals have started flying drone cameras for aerial photography and videography. But flying a drone is not easy for beginners; one should follow instructions carefully while flying a drone camera. So, here are few very important instructions enlisted:
STEP 1: CONNECT YOUR PROPELLER WITH A DRONE
Insert the black propeller with the black ring & the white propeller with the
white ring. Don’t push too hard while inserting propeller in drone ring. If
you’re using much force while pushing, it may result in damaging the
motor.
STEP 2: INSERT BATTERY IN YOUR QUADCOPTER/DRONE
Always check that your battery pin has bottom end & switch on/off button
towards right hand side. Charge your battery 100% before flying a drone
camera because the life cycle of charged battery would be 15-20 minutes
only, so be careful.
STEP 3: INSERT MEMORY CARD IN YOUR DRONE CAMERA
Always remember, your card pin must be upper side & don’t forget to
format your memory card before you start to flying drone. You can format
memory card through your phone using the app. It is always advisable to
carry spare memory cards.
STEP 4: INSTALL DJI APP IN YOUR IPAD/ANDROID MOBILE PHONE
Firstly, connect your iPad/mobile phone with remote. Before using drone,
always put your mobile on aeroplane mode. If you don’t do that, you might
get a call while flying and consequently connection could be lost.
STEP 5: NOW CHOOSE A TAKEOFF LOCATION (PREFERABLY OPEN AREA/GROUND)
Always remember camera’s face should be opposite to your position.
Keep in mind, if in any case, the camera faces the operator; all the
controls of remote will be reversed. Avoid accident by not flying drone in a
closed space or stormy weather. Always look for an open space for flying.
STEP 6: SWITCH ON THE DRONE POWER BY PRESSING THE BATTERY BUTTON TWICE
Always check twice that your phone and drone remote work properly
before you start to flying drone. Don’t take risk of flying a drone if battery
isn’t fully charged. Uncharged batteries often result in crash landing.
STEP 7: PULL BOTH THE JOYSTICKS DOWNWARDS TO START THE PROPELLER
Your rotary wings spin in opposite direction. Now, you are ready to fly your
drone camera. Once the drone has started flying make sure, there is no
sound other than motor’s. Also, check if there is any error message on the
phone screen.
STEP 8: TO GO UP & DOWN, PUSH LEFT JOYSTICK UP & DOWN
To fly a drone, keep moving the joystick to the left side. Avoid pushing
joystick with jerk. If there are jerks while using joystick, there can occur
problem with motor system. To move/rotate drone camera towards left &
right, push left joystick left & right.
STEP 9: TO GO FRONT & BACK SIDE, PUSH RIGHT JOYSTICK UP & DOWN.
FOR LEFT & RIGHT MOVEMENT, PUSH THE RIGHT JOYSTICK LEFT & RIGHT
Make sure, drone is there in front of your eyes. Its direction shouldn’t be
changed at any point of time.
STEP 10: FOR LANDING, PULL DOWN THE LEFT JOYSTICK SLOWLY
Always avoid high-speed landing. Before the drone touches the surface,
release the joystick to the center & gently pull down the left joystick for a
smooth landing. To turn off the motor/propeller, pull down the left joystick
& hold for 3 seconds. After rotary wings are stopped, switch off the battery
& remote by pressing their button.