Embed Size (px)
Citation preview
Analysis Services Case Study: You Can’t Mold That Part – Here’s Why
Christopher MaLead Analysis Services Engineer
Agenda
§ Introductions§ Background Information§ The Goal§ How We Helped§ The Outcome§ Summary and Closing Remarks
Introductions
§ Christopher Ma, Lead Analysis Services Engineer§ 5 years with Hawk Ridge Systems, Majority Spent
Focusing on SolidWorks Simulation§ B.S. in Mechanical Engineering, University of California at Santa Barbara§ M.S. in Mechanical Engineering, University of California at Los Angeles§ CSWE, CSWP, Elite Applications Engineer
§ Jared Conway, Analysis Services Manager§ 9 years with Hawk Ridge Systems, Majority Spent
Focusing on COSMOS/SolidWorks Simulation§ B.S. in Aerospace Engineering, University of Manitoba§ P.Eng registered in Manitoba, Canada
§ Paolo Olmos, Analysis Services Engineer§ 3 years with Hawk Ridge Systems, Majority Spent § Focusing on SolidWorks Simulation§ B.S. in Mechanical Engineering, San Jose State University§ CSWE, CSWP
Background Information
§ Have you been in a situation where you knew your answer was correct but didn’t have an immediate way to prove it?
§ …that’s never going to work.
§ …that design is way too flimsy.
§ …there’s got to be a better way to do that.
Background Information
§ STAMCO Specialty Tool & Manufacturing Co., a customer of HRS, was designing mold tooling for a customer of theirs.§ www.stamcotool.com
§ The tooling was for a 24” diameter plastic cap, to be fitted on the end of a pipe.
§ Could the spec’d injection molding machine handle this part?
Background Information
§ Initial guesses§ Experience§ Rule of thumb calculations§ Online calculators
Background Information
§ Four approaches that they could take:§ Ignore due diligence.§ Physically test.§ Purchase software to analyze in-house.§ Hire a consultant to analyze for them.
§ STAMCO decided to go with HRS Analysis Consulting.
How Hawk Ridge Systems Helped
§How did we fit into STAMCO’s process?§We are translators!§What was our goal?
Discovery Execution Results
The Goal
§ Determine the required clamp tonnage for the part.
How Hawk Ridge Systems Helped
§§§How did we accomplish our goal?
Execution Results
The Outcome
Results
Conclusion
• Based on the required clamp tonnage reported by SolidWorks Plastics and from rule-of-thumb calculations, the machine that was spec’d out to mold the part had insufficient clamp tonnage.
Summary
• STAMCO was concerned that their customer’s part could not be molded.
• STAMCO wanted to do their due diligence and get another validation point on whether the part would mold.
• By partnering with HRS Analysis Services, STAMCO was able to get that additional source of validation.
Closing Remarks
• Do you have a similar situation?
• Do you have a structural, thermal, or fluid flow problem?
• Don’t hesitate to contact us. Big project or small project; let us turn your design concern into an analysis question and answer.
Closing Remarks
§ Who do I contact for more information?§ Analysis Services§ Christopher Ma - [email protected], 650-230-7019§ Paolo Olmos – [email protected], 650-230-7033§ Jared Conway – [email protected], 650-230-7006
§ Software§ Your local sales rep, [email protected], or our toll free
numbers§ Free Analysis Consultation
§ More information on our website, www.hawkridgesys.com
Hawk Ridge Systems Analysis Servicesemail: [email protected]: 650.230.7019
New & Existing Recorded Webinars: http://www.hawkridgesys.com/tutorials/
Thank you for attending!
Your NameYour Title
877.266.4469 US 866.587.6803 CAN
