Upload
vinayvickky
View
97
Download
4
Embed Size (px)
Citation preview
A Seminar
on BRUSHLESS DC MOTOR
Submitted in partial fulfillment of the Requirements for the award of BACHELOR OF TECHNOLOGY
InELECTRICAL AND ELECTRONICS ENGINEERING
By V.VINAY (167 05A0248)
II B.Tech EEEUnder the esteemed guidance of
Mr. C. GANESH, M.Tech ,Associate Professor
DEPARTMENT OF ELECTRICAL AND ELECTRONICS ENGINEERINGANNAMACHARYA INSTITUTE OF TECHNOLOGY AND SCIENCES, RAJAMPET
(An Autonomous Institution)2016-17
Brushless DC Motors
Contents…• Introduction• Motor basics• Principles of BLDC motor• Construction• Hall sensors• How it works• Torque/speed characteristics• Advantages• Disadvantages• Applications• Conclusion
Introduction…• Classical DC motors are no doubt good and
simple but inefficient in some ways.• Although dc motors possess good control
characteristics and ruggedness, their performance and applications are inhibited due to sparking and commutation problems.
• The Permanent Magnet Brushless DC (PMBLDC) motor is able to overcome the limitations mentioned above and satisfy the requirements of a variable speed drive.
• What is a motor Converts electrical energy into kinetic energy• How it works
Motor Basics
Brushless DC Motor(BLDC)Principles• A BLDC is simply a normal dc motor turned inside out, that means the coil is on the out side and the magnets are inside• The stator consists of several coils which current is led through Creating a magnetic field that makes the rotor turns
Construction• Stator consists of stacked steel laminations with windings placed in the slots that are axially cut along theinner periphery
• Rotor is made of permanent magnet and can vary from two to eight pole pairs with alternate North (N) and South (S) poles. Ferrite magnets and Rare earth alloy magnets are used in rotor
Unlike a brushed DC motor, the commutation of a BLDC motor is controlled electronically.
It is important to know the rotor position in order to understand which winding will be energized following the energizing sequence.
Rotor position is sensed by different ways some of them are1) Hall sensors2) Optical encoders
Hall Sensors
When a magnetic field applied to a system with electric current a hall voltage Perpendicular to the field and to current is generated.This was discovered by Edwin Hall in 1879.
How it works
• Halls Sensors sense the position of the coils
• The Decoder Circuit turns appropriate switches on and off
• The voltage through the specific coils turns the motor
TORQUE/SPEED CHARACTERISTICS
Advantages • Increased Reliability & Efficiency
• Longer Life
• Elimination of Sparks from Commutator
• Reduced Friction
• Faster Rate of Voltage & Current
Disadvantages
• Requires Complex Drive Circuitry
• Requires additional Sensors
• Higher Cost
• Some designs require manual labor (Hand wound Stator Coils)
ApplicationsConsumer: Hard Drives, CD/DVD Drives, PC Cooling Fans, toys, RC airplanes, air conditioners
Medical: Artificial heart, Microscopes, centrifuges, Arthroscopic surgical tools, Dental surgical tools and Organ transport pump system.
Vehicles: electronic power steering, personal electric vehicles
Airplanes: an electric self launching sailplane, flies with a 42kW DC/DC brushless motor and Li-Ion batteries and can climb up to 3000m with fully charged cells
Conclusion
• Although Brushless DC Motors are more expensive of the same kW rating than conventional DC Motor but there are many advantages.
• Brushless DC Motors can run when submerged in fluids.
• Brushless DC Motor does not produce brush or commutator particles or gases as by-products of operation.