MOLDING, CASTING AND COMPOSITES

(MAR 7)

WALTER GONZALES ARNAO

FAB ACADEMY 2012

THE JOB IS TO MAKE A 40X30 40X PART IN A MECHANICAL WAX

MOLD, USING THE MACHINE ROLAND

SUMMARY

FIRST JOB IN THE SOFTWARE IS DRAWING TO DEFINE THE

GEOMETRY OF THE PIECE

STEP TWO. INTRODUCED THE SAVE THE FILE TO STL Open it THEN THE SOFTWARE THAT MADE LAQUINA MACHINING WITH STRAWBERRY 3mm FLAT

STEP THREE. IS THE SIMULATION SOFTWARE IN THE MACHINE TO SEE

THE PATH OF THE STRAWBERRY IN THE WAX PEZA machinable

STEP FOUR. STANDING IN THE STRAWBERRY 3mm MACHINE TO

PROCEED TO MACHINING

STEP FIVE. PULLS THE PART OF THE ROUTER PAR WAX

PROCEED TO REMOVE THE WAX TO LET TAILINGS CLEAN

STEP SIX. APPLICANTS ARE TO FIT THE MOLD Mescla FLEXIBLE

step seven, we proceed to give the flexible part assembly that

will be the mode

step eight, the flexible mold is prepared to fill it with white

cement

Step nine, white cement is placed and then is expected to

disassemble

step ten, is corrected by removing faults early, mold

step eleven, final part

end