CORK SHOOTER

Firstly, attach the 3 craft sticks with one on top of the other for the basement of the structure by using hot glue.

Secondly, 2 cubes are placed close together and 1 at the end to support the trigger. Covered with another 3 craft sticks for the top of the structure.

Then, the trigger (clothespin) is glued on.

In forth step, the firing rubber band is attached to the trigger. Before that, Use a utility knife or other tool to cut a piece of cork into a disk shape.

Another step is use two fingers to pull the rubberband back into the open trigger. Close the trigger, then let go of the rubberband. Then, insert the cork disk between the strands of taut rubberband.