LITEAIRAUTO8-V1
LITEAIRAUTO8A-V1
Please ensure that when installing this product the heatsink will not contactwith any materials that mat be damaged by heat such as upholstery or plastics.
Connect to +12V of battery withattached 20 amp fuse
Connect to chassis ground ofvehicle Connect to chassis ground of
vehicle
Connect to speaker outputof headunitR + white R - white / blackL + grey L - grey / black
Connect to RCA (low level) outputof headunit
Connect to supplied bass remote
NOTE: if the remote is not connected the amplifier will default to minimum frequency and minimum gain setting
LITEAIRAUTO8A-V1
R L REM GND
+12V
RL
Connect to Speaker output of amplifierNOTE: VIBE recomends the LiteAir Bass 1amplifier as the perfect partner for the LITEAIRAUTO8-V1
LITEAIRAUTO8-V1
The LiteAir Auto 8 subwoofer enclosure can be mounted in many different locations in the vehicle due to it’s shallow profile.
Below are a few examples of different mounting applications that are possible with the LiteAir Auto 8 subwoofer enclosures.
Rear of seat
Under seat
Side panel
Please follow the installation method below to secure the enclosure to your chosen mounting location.
Step 1: Fold out the steel mounting tabs from underneath the enclosure
Step 2: Secure the enclosure with 4 screws.
Note: Be sure to investigate your mounting area thoroughly for electrical wires, brake or fuel lines or fuel tank to prevent causing any damage.If you are unsure VIBE recommend that the enclosure is installed by an authorised VIBE dealer.
Terminals & controls
LITEAIRAUTO8-V1 LITEAIRAUTO8A-V1
1
7 2
3 4
68
9 5
1.
2.
3.
4.
5.
6.
7.
8.
9. Speaker terminalConnect to the speaker output of the amplifier
LiteAir Optisound Auto 8
LiteAir Optisound Auto 8 active
Part Number: LITEAIRAUTO8-V1
Peak Power: 900 watts
RMS Power: 300 watts
Height: 80mm (excl grill)
Width: 285mm
Depth:Impedance:
397mm
Part Number: LITEAIRAUTO8-V1
Peak Power: 900 watts
RMS Power: 300 watts
Height: 80mm (excl grill)
Width: 285mm
Depth: 395mm 20 amp
4 Ohms
Fuse rating:
20 amp fuse