Material Safety Data Sheet
Section 1-Chemical Product and Company IdentificationTrade Name of Product: Sodium lignosulfonateSynonym:Sodium lignosulfonateChemical name:Lignosulfonate acid Sodium saltChemical Formula:not availableContact InformationAdd:3-608, Yinhe Mansion, 2008 Xinluo St., High-Tech Dist., Jinan, Shandong, China (Mainland)Tel:0086-531-88818639Mobile:0086-155-8888-9390Email:[email protected]://www.greenagrochem.comSection 2-Composition Information on IngredientsCompositionDry matter 95%minLignosulfonates 50-60%Section 3-Hazards IdentificationPotential Acute Health Effects:no specific information available in our databank regarding theacute effect of this material for humans.Route of Entry: Eyes, Inhalation, Skin and IngestionSection 4-First Aid MeasuresInhalation: Remove person to fresh air and support breathing as needed, Seek medical attention ifirritation persists.Ingestion :Seek medical attention or call a poison control center immediately.Skin: No poisonous to skin. Remove contaminated clothing and wash before reusing. Flush skinwith water, and then wash with soap and water. Seek medical attention if skin becomes irritated.Eye:In such case flush eye immediately for at leat 10 minutes .Get medical attention.Section 5-Fire and Explosion Hazard DataFlammability of the product:may be combustible at high temperature.Flash point: Non-availableFlammable limits: Non-availableProduct of combustion:Non-availableSpecial remarks on fire hazards:Non-availableSpecial remarks on explosion hazards:Non-availableSection 6- Accidental Release MeasuresSmall Spills: Clean up personnel should protect against mist inhalation and skin contact. Avoidgenerating mists, Spills when handling should be cleaned up immediately to prevent spreading.Large Spills:use a shovel to put the material into a convenient wast disposal container.Finishcleaning by spreading water on the contaminated surface and allow to evaluate through thesanitary system.Section 7- Precautions for Safe Handling and UsePrecautions to be taken in handling and storing: Store in cool, dry areas away from children, feed
and food products and sources of heat, Immediately clean up spills that occur during handling orstorage.Protect from freezing keep containers closed when not in use.Section 8-Control Measures/Personal ProtectionRespriatory Protection: Seek professional advice prior to respirator selection and use.Section 9-Physical/ Chemical CharacteristicsPhysical state and appearance :Powder solidOrder:slightMolecular weight:Not availableColor:yellow brownBoiling point:Not availableMelting point:Not availableCritical temperature:Not availableSpecific gravity:Not availableVapor pressure:Not availableVapor density:Not availableSolubility:easy soluble in cold water and hot water.Section 10-Reactivity DataStability:Product stable at room temperature in closed containers under normal storage andhandling conditionsChemical Incompatibilities:Strong bases and AcidsCondition to avoid:Avoid excessive heat.Section 11-Toxicological InformationEye Effects:IrritationSkin Effects:May cause irritationAcute Inhalation Effects:Not DeterminedChronic Effects:No unusual chronic effectsCarcinogenicity:Not listed as carcinogenicSection 12-Ecoligical InformationSoil Absorption/Mobility:Mobile in soil profileSection 13-Disposal ConsiderationsDisposal:Dispose of in an approved landfill or apply at recommended label rates.Disposal Regulatory Requirement:Follow applicable Federal,State and local regulationsSection 14-Transport InformationNot regulated by the DOTSection 15-Regulatory InformationSudden Release of Pressure:No Immediate:YESFire:No Delayed:NoReactive:NoSection 16-OtherDisclaimer:All information appearing herein is based upon data obtained from manufactuersand/or recognized technicalsources. While the information is believed to be accurate, we make no representations as to itsaccuracy or sufficiency.