WHITESPIRIT
16-24h
up to15M2/L
6-16h
up to14M2/Lup to8M2/L
12h
up to12M2/L
2-4h
WATER
WHITESPIRIT
16-24h
up to15M2/L
6-16h
up to14M2/Lup to8M2/L
12h
WATER
up to12M2/L
2-4h
Sealing new/bare surfaces: Add up to 1 part clean water to 5 parts paint. Normal use (not to be exceeded): Add up to 1 part clean water to 10 parts paint. Conventional spray application: Add up to 1 part clean water to 2.5 parts paint. Airless spray application: Add up to 1 part clean water to 5 parts paint. Conventional spray : Satisfactory through most equipment.
4-6hWHITESPIRIT
16-24h
up to15M2/L
6-16h
up to14M2/Lup to8M2/L
12h
WATER
up to12M2/L
up to9M2/L
4-6hWHITESPIRIT
up to16M2/L
16-24h
up to15M2/L
6-16h
WATER
up to14M2/L2-4h
Allow new surfaces to dry out completely. Remove all loose or defective paint or powdery residues by thorough brushing and scraping, using a stiff "bre brush. Treat any areas affected by mould, lichens, algae and moss with *Weathershield Multi-Surface Fungicidal Wash. Make good minor defects. Use a sand and cement mix for larger holes and cracks. Allow to dry. Surfaces that remain powdery, friable or chalky after thorough preparation should be sealed with Armstead Trade Stabilising Primer. Note: Do not seal sound new or bare surfaces with stabilising primer. Do not apply Armstead Trade Smooth Masonry Paint during wet or frosty weather. Common #etton bricks should not be painted (see BRE Information Paper Number IP22/79, Painting of Common Fletton Brickwork). Note: Special precautions should be taken during surface preparation of pre-1960s paint surfaces over wood and metal as they may contain harmful lead.
SMOOTH MASONRY
AM302
PRODUCT DESCRIPTION & USE
Armstead Trade Smooth Masonry Paint is a professional quality, smooth exterior emulsion paint. It has an attractive high build "nish and provides excellent coverage and application.
PACK SIZES
COLOUR RANGE
Armstead Trade Exclusive: 79 colours BS4800: 98 colours RAL: 44 colours NCS 1 & 2: 70 colours
Visit www.armsteadtrade.co.uk
FILM PROPERTIES
Chemical Resistance: Resistant to mild atmospheric fume attack and to the salts in new mortar, rendering and similar surfaces.
Heat Resistance: Not suitable for use on heated surfaces. Water Resistance: Resistant to the levels of atmospheric
humidity normally experienced in exterior environments.
COMPOSITION (NOMINAL)
Pigment: Lightfast Pigments. Binder: Acrylic Copolymer Emulsion. Solvent: Water.
VOLUME SOLIDS
36% (nominal) for Brilliant White, colours will vary.
APPLICATION
Brush, roller, spray & airless spray. As with other water-based paints, do not apply in temperatures below 8ºC (as recommended by British Standard BS 6150)
DRYING TIMES (SINGLE COAT, STANDARD THICKNESS)
Touch Dry: 1-2 hours* Recoat: 2-4 hours* *Drying time will vary according to temperature and humidity e.g. the drying times quoted will be signi"cantly longer in cold, damp conditions.
PRACTICAL COVERAGE
From 6 up to 12m2 / litre depending on surface texture. These "gures are only an approximate guide and may be reduced. If in doubt, apply a small trial area "rst.
THINNING
SPRAY RECOMMENDATIONS
Conventional Spray: Satisfactory through most equipment. Airless Spray: A typical recommendation for airless spray
application is a minimum working pressure on paint of 140 kg/cm2 (2000 Ib/sq in) with a spray tip size 0.38mm (15 thou) and a spray tip angle 65°.
CLEANING UP
After use, remove as much paint as possible from brushes before cleaning with clean water.
SURFACE PREPARATION
KEY BENEFITS
• Up to 15 years protection • Shower resistant in 30 minutes • Anti-Carbonisation properties
SYSTEM INFORMATION
Stir thoroughly before use. On very absorbent surfaces apply a sealing coat of thinned Armstead Trade Smooth Masonry Paint. The normal "nishing process is 1 or 2 coats of Armstead Trade Smooth Masonry Paint.
5L
(Not all colours are available in both pack sizes.)
10L
Issued August 2014
Page 1 of 2
EU limit value for this product (cat A/c) : 40g/l (2010) This product contains max. 8g/l VOC *Weathershield Multi-Surface Fungicidal Wash contains: Benzalkonium Chloride. Use biocides safely. Always read the label and product information before use. VOC Content Low 0.30% - 7.99%. VOCs (Volatile Organic Compounds) contribute to atmospheric pollution.
VOC
FURTHER SUPPORT
Online: www.armsteadtrade.co.uk Email: [email protected] Phone: 0333-222-70-70 Please visit www.armsteadtrade.co.uk to download safety sheet SDSAM302
AkzoNobel, the AkzoNobel logo, Dulux Trade Weathershield and Planet Possible are trademarks of the AkzoNobel group © AkzoNobel 2014
Let’s create together a better future for our planet. Find out how at: www.armsteadtrade.co.uk/pp
Like us on Facebook
Follow us on Twitter
Videos on YouTube
SMOOTH MASONRY
AM302 Issued August 2014
Page 2 of 2
TRANSPORTATION & STORAGE
Do not use or store in extremes of temperature and protect from frost. To prevent spillage, please store and transport upright.