Turn the headset off. Place the headset on a level surface, front side down. Using the No. 1 Phillips head screwdriver, remove the two screws from the back of the headset next to each bow arm.

 

Replacing the Battery

USA Corporate Office:TV Ears Inc.2701 Via Orange Way, Suite 1Spring Valley, CA 91978Phone (888)883-3277 Fax: (888)958-7899www.tvears.com © 2010 TV Ears, Inc. All rights reserved.

If you need further assistance, please contact the place of purchase

Place the new faceplate with batteries on the headset and carefully turn the headset over.Gently put the screws in place and attach the new faceplate with the screwdriver.

Place the headset on the transmitter-charging cradle and allow your TV Ears to charge for 8 – 10 hours.

Turn the headset over and remove the faceplace with the logo and batteries attached.

What you need for replacement: Headset, Replacement Faceplate with New Battery (should be the same model as your headset), & No. 1 Phillips head screwdriver

Step | 1 Step | 2

Step | 3 Step | 4

 

Instructions

front

back