2900 WESTINGHOUSE BLVD. SUITE 106CHARLOTTE , NC 28273
704 / 504 / 1127 PH 704 / 504 / 1115 FX
888 / 666 / 5090 TOLL FREE WWW.SOUNDISOLAT IONCOMPANY.COM
M A D E I N
T H E U S A
1/8” Sound Blocking Layer
Insulation
StandardCeiling Tile
PRIVACY CEILING BLOCKER TILE™Basement renovations, office spaces, even mixed use commercial spaces all present challenges that sometimes make a suspended grid ceiling the only choice. Mechanical ducts, plumbing and wiring conduits, uneven joist, and sloped joist are several reasons where hiding what’s there is the best option.
Grid system ceilings are too light to help in the creation of privacy between spaces; the only traditional options are very expensive ceiling tiles with sheetrock as the backer, or foil backed tiles which are touted as high performance noise blockers but really aren’t even capable of bare minimum STC ratings.
We have a simple, very effective solution for all suspended grid ceilings. Available in pre-cut sizes Privacy Ceiling Blocker Tiles are designed to fit directly above your current ceiling tiles. Tested to a STC 26, you can expect immediate improvement in the sound blocking of your grid ceiling.
You do not have to make any modification to your existing ceiling, and you don’t have to replace the tiles you already have. This system is simple to install by a maintenance man, or even by yourself.
Privacy Ceiling Blocker Tiles are available in two versions, one with quilted absorber layer (PPBT), and one without the quilt (PCBT).
TECH SPECIFICATIONS
ITEMABSORBER LAYER
FIRE RATING
STC VALUE SIZES WEIGHT
PPBT YES CLASS A 32 2X2, 2X4 1.25 lb/sft
PCBT NO CLASS A 27 2X2, 2X4 1.0 lb/sft
Custom configurations and sizes available by quote.
Solve your noise problem. Call now to get it right the first time 888-666-5090With Sound Isolation Company you will get the help you need: expert design, product selection and installation instruction. We have the experience you need for a partnership that will work.
SOUNDPROOF YOUR EXISTING GRID CEILING
FOR COMMERCIAL AND RESIDENTIAL JOBS
READY TO INSTALL, ALREADY CUT TO SIZE
PRIVACY CEILING BLOCKER TILEIMPROVE YOUR DROP CEILINGS
Privacy Premium Blocker Tile is Cut To Size
Soundproofing Made Simple (888) 666-5090 | Fax: (704) 504-1115info@soundisolationcompany.comwww.soundisolationcompany.com
Privacy Soundproof Light Covers (PSLC)
UL Fire Rated CeilingsUL Ceilings require that all fixtures be covered with a UL Certified light cover. To maintain the fire rating for your ceiling the simplest, cost effective method is to use PSLC. Privacy Light Covers are UL Approved in both commercial and wood frame construction. Simple three piece design goes together in minutes. PSLC’s are very easy to modify for electrical or bracket penetrations, and suitable for air supply fixtures; save money and time by using Privacy Soundproof Light Covers.
Soundproofing PenetrationsYour soundproof ceiling will only perform as well as the weakest link. Recessed fixtures, speakers and any other penetrations will act as “holes” in the ceiling where soundproofing is concerned. PSLC are a simple, effective way to maintain the sound rating for your ceiling. The same principles apply for sheetrock or drop grid ceilings. Independent testing confirms that the sound rating for a ceiling with no recessed lights will remain the same with cans and Privacy Soundproof Light Covers.
Flexible SizingPrivacy Soundproof Light Covers are available to fit any fixture up to 24” x 48” at any height. Custom sizes can be accommodated as well. Low profile options are available when height is a concern. When compared to other light covers or field fabrication of drywall boxes the delivered, installed cost of PSLC makes the choice very easy.
Solve your noise problem. Call now to get it right the first time 888-665-5090
SOUNDPROOFING COVER FOR ALL CEILING FIXTURES INCLUDING LIGHTS, SPEAKERS AND OPEN VENTS
APPROVED FOR 1 HR FIRE RATED CEILINGS
UL LISTED IN OVER 50 CEILING DESIGNS
• Privacy Fire Rated Light Covers will providefire protection to meet code, and realsoundproofing performance.
• Low profile soundproofing light covers forany fixtures, ready to install in minutes.
• Standard sizes in stock for quick ship,custom sizes in two weeks
PRIVACY SOUNDPROOF LIGHT COVERS (PSLC)
M A D E I N
T H E U S A
Toll Free: (888) 666-5090
Soundproofing made simple
www.soundisolationcompany.com
13-614.5
Privacy SoundproofLight Covers
Support Wire
Florescent Light Fixture
Ceiling Tile
Privacy SoundproofSpeaker Covers
Support Wire
Ceiling Speaker
Privacy SoundproofReturn Air Cover
Support Wire
Open Air Plenum Return
Commercial Light Fixtures
Ceiling Speakers and Down-Lights / Recessed Cans
PRIVACY SOUNDPROOF COVERS FOR LIGHTS, OPEN GRID VENTS AND SPEAKERS
Soundproofing made simple
2900 Westinghouse Blvd. Suite 106 n Charlotte, NC 28273Phone: (704) 504-1127 n Toll Free (888) 666-5090 n Fax (704) 504-1115 n www.soundisolationcompany.com
Place cover over light and align with grid. Mark and slit for power cable and any support wires.
Place cover over fixture, align slits with power cable and wires before dropping into place. When aligned drop cover into place, Stick pins will extend through the cover. Install square pin washers to secure in place. Tape and seal all slits with reinforced foil tape (FSK).
Remove cover and apply peel and stick pins, with spacer, to top of fixture; center for 2x2 fixture, both ends for 2x4.
Align and secure end caps with provided stick pins. No washers are used here.
Privacy SoundProofing Light coverS™(PSLc) - inStaLLation guide If you have any questions after reading this entire document, call the factory before starting the installation.
inStaLLation guide for commerciaL fLuoreScent fixtureS
1
3
2
4
DISCLAIMER: These application notes represent generally accepted procedures for successful installation. Sound Isolation Company reserves the right to alter these suggestions and encourages contact with the factory or its representatives to review any possible modification to these application notes prior to commencing installation.
ContRACtoRS REpoRt typICAL InStALLAtIon CAn bE pREfoRMED In About 6 MInutES.
2900 Westinghouse Blvd. Suite 106 n Charlotte, NC 28273Phone: (704) 504-1127 n Toll Free (888) 666-5090 n Fax (704) 504-1115 n www.soundisolationcompany.com 10-351
Privacy Recessed Light CoverTransmission Loss Testing
Privacy Recessed Light CoversTransmission Loss Sound Testing
Privacy Recessed Light Covers have been tested to determine the change in ceiling noise blocking capabilities when can lights are added to the ceiling. A gypsum board ceiling was constructed and tested for STC (airborne sound blocking) and IIC (footstep noise blocking). The sound blocking results are listed below as Original Ceiling.
In the test lab a typical floor system with plywood floor, trusses, insulation and drywall ceiling is built that measures 16’ x 12’. The first test is with no penetrations, the second was done with nine 6” can lights and Privacy Recessed Light Covers.
As the data below demonstrates the STC (airborne sound blocking) is actually better with the can light and cover except at 125 Hz (-.6 decibel) and 250 Hz (-.2 decibel). The IIC (footstep blocking) was better at every frequency except 100 Hz (-.5 decibel). The small drops in performance would not be noticeable without a sound level meter.
CONCLUSION In summary you can install can lights, using Privacy Recessed Light Covers and keep the sound rating of your floor/ceiling the same. This is particularly important when you collaborate with us to create a luxury rated floor/ceiling, as previously there was no effective, simple option to protect the sound ratings when recessed lights are used.
Original CeilingCeiling with cut-out and Privacy Covers
125 Hz 24.6 25.0
250 Hz 36.0 35.0
500 Hz 39.2 39.7
1000 Hz 45.4 45.5
2000 Hz 44.0 43.8
4000 Hz 50.0 51.2
Original CeilingCeiling with cut-out and Privacy Covers
125 Hz 82.6 83.7
250 Hz 81.6 82.0
500 Hz 82.9 83.3
1000 Hz 75.0 74.5
2000 Hz 64.5 64.3
4000 Hz 51.4 52.2
20
25
30
35
40
45
50
55
125 Hz 250 Hz 500 Hz 1000 Hz 2000 Hz 4000 Hz
Original CeilingCeiling with cut-out and Privacy Covers
50
55
60
65
70
75
80
85
125 Hz 250 Hz 500 Hz 1000 Hz 2000 Hz 4000 Hz
Original CeilingCeiling with cut-out and Privacy Covers
AIRBORNE SOUND IMPACT SOUND
Soundproofing made simple
2900 Westinghouse Blvd. Suite 106 n Charlotte, NC 28273Phone: (704) 504-1127 n Toll Free (888) 666-5090 n Fax (704) 504-1115 n www.soundisolationcompany.com
Place cover over light and align with grid. Mark and slit for power cable and installation framing so cover will rest flat on the ceiling tile or drywall.
Align and secure end caps with provided stick pins. Tape and seal all slits with reinforced foil tape (FSK).
Align slits with power cable and mounting hardware before dropping into place. When aligned drop cover into place, and configure so it is flat on ceiling tile or drywall
Privacy SoundProofing Light coverS™(PSLc) - inStaLLation guide If you have any questions after reading this entire document, call the factory before starting the installation.
inStaLLation guide for receSSed can Light fixtureS
1
3
2
DISCLAIMER: These application notes represent generally accepted procedures for successful installation. Sound Isolation Company reserves the right to alter these suggestions and encourages contact with the factory or its representatives to review any possible modification to these application notes prior to commencing installation.
ContRACtoRS REpoRt typICAL InStALLAtIon CAn bE pREfoRMED In About 6 MInutES.