Rig
size
Clamping ext range
Min stoping width
Max stoping width
750mm 1.250m 800 1.250m750mm 1.250m 800 1.250m
1m 1.90m 1.20m 1.90m
1.3m 2.50m 1.50m 2.50m
1.7m 3.30m 2.0m 3.30m
Rig size
Mass excl drill incl control kg
Typical mass incl std drill kg
Mass of controls
750mm 39 kg 62 kg 6.5 kg750mm 39 kg 62 kg 6.5 kg
1m 42 kg 65 kg 6.5 kg
1.3m 49 kg 72 kg 6.5 kg
1.7m 52 kg 75 kg 6.5 kg
� Built-in drill rig jack = +- 80 kg force for clamping
� Remote drilling operation as far as 5 m away
� Reduced noise levels due to remote drillingremote drilling
� No vibration of machine on operator
� Operator’s remote controls under supported roof
� Light weight – easy to move around
� One man operation
� Accurate drilling due to proper clamping of machine
� Can use any drill type i.e.: Board range or Compair
� Light weight� Light weight
� Easy to handle with wheels on unit
� Reliable unit
� Cost effective
� Low repair cost
� Same rig can be used in areas from 900mm higher than the rig size, no larger rigs necessary
� Anglo Platinum RPM – Paardekraal,
Townlands and Union Mine
� Xstrata Platinum and Chrome
International Ferro Metals� International Ferro Metals
� Lonmin – Saffy, Hossy and Newman Shafts
� Aquarius Kroondal Platinum
� We have a workshop situated in Thlabane Rustenburg.
� Rigs can be collected daily from the shafts to be repaired
� Turn around time is 3 working days maximum
� Repair cost to be kept to a minimum – depending on the minimum – depending on the severity of any structural damage
� Repairs done on a “strip and quote basis” or fixed repair cost.
� Demonstrators to help with training free for 2 days with every new rig purchased
� Service exchange rigs available for emergency breakdowns
Recommended