Personal Protective Equipment
PPE
Training Objectives
After completing this unit, you will be able to:– Recognize hazards and understand controls,
including Personal Protective Equipment (PPE).
– Understand PPE & the standards it must meet.
– Identify requirements for a respirator program and
its components.
– Define air-purifying & supplied-air respirators.
– Perform negative & positive respirator fit checks.
1SUBPART
E PPE
References
29 CFR 1926.95-107; Subpart E, PPE American National Standards Institute
(ANSI) (Various) National Institute for Occupational
Safety and Health (NIOSH); Respirator Approval.
Mine Safety and Heath Administration (MSHA); Respirator Approval.
2SUBPART
E PPE
The Hazards of Construction
The tools, materials, and processes of construction create hazards.
Those can affect your safety or health. Hazards can hurt you if they are not
eliminated or controlled. Your employer must eliminate or control
the hazards you are exposed to!
3SUBPART
E PPE
Construction Hazards
Safety-Related– Electrocution– Falls– Falling objects– Flying objects– Lifting– Hot objects– Crushing
Health-Related – Noise– Chemical Vapors – Gases– Lack of oxygen– Asbestos dust– Vibration
4SUBPART
E PPE
How Hazardous is Construction?
There are more lost-time injuries in construction than in any other industry.
Each year, one in seven workers will miss work because of an injury (most will not be wearing safety gear).
Nearly one in five construction deaths are because of exposure to harmful chemicals.
5SUBPART
E PPE
Hierarchy of Controls
Elimination/Substitution - use a less harmful substance in process
Engineering Controls - Closed systems, ventilation
Administrative Controls - Worker rotation, training & education
Personal Protective Equipment - Use secondary to controls already in place
Why is PPE Often the Choice? Construction work is
full of hazards. Safer methods or
products don’t exist. Engineering or
administrative controls may not be practical.
PPE is the last line of defense, but common in construction.
7SUBPART
E PPE
Types of Personal Protective Equipment
Most Common– Head Protection– Foot and Leg– Hearing– Eye and Face– Respiratory – Torso Protection
Other Types– Reflective
clothes– Life vests– Safety nets– Lifelines– Safety
harnesses– Lanyards
8SUBPART
E PPE
Who Approves PPE?
OSHA does not approve PPE. OSHA-acceptable PPE will be approved
by one of the following agencies:
– NIOSH (National Institute for Occupational Safety & Health).
– ANSI (American National Standards Institute).
– MSHA (Mine Safety & Health Administration).
SUBPART
E PPE 9
Protecting Your Head Each year construction workers have
thousands of head injuries. Hard hats are required in areas where
injury from impact, falling objects, or from flying objects is possible.
Hard hats must meet ANSI Z89.1(1969). Hard hats should be inspected often. Don’t paint, cover with stickers or
wear backwards.
SUBPART
E PPE 10
Use PPE As Intended
What does the manufacturer say?
11SUBPART
E PPE
Types of Hard Hats
Class A: General service– Most construction workers wear this type.
Class B: Electrical service– These protect from high voltage.
Class C: Bump Caps, usually aluminum– These are not acceptable for construction.
12SUBPART
E PPE
How do Hard Hats Work?
Very well, if worn correctly!
The suspension absorbs shocks and keeps the shell away from your skull.
Make sure you have at least one inch clearance between the suspension and the outer shell. Meets ANSI Z89.1-1997;
tested to withstand a 16 ounce hammer dropped 40 feet.
13SUBPART
E PPE
Noisy Facts
Noise increases your blood pressure and wears you out.
You are naturally going to lose some hearing with age.
Work-related hearing loss plus natural loss will make it hard for you to enjoy retirement.
Hearing loss is sneaky because you can be hurting yourself without pain.
14SUBPART
E PPE
Protecting Your Hearing Use plugs or muffs. Follow the manufacturer’s
instructions. They must fit properly and
be maintained. Remember, they only work if used. Do not use cotton or other
home-made protection.
18SUBPART
E PPE
When Do You Need Protection?
OSHA requires protection whenever noise is 90dBA or above for an 8-hour day.
Louder noises for shorter periods and impact noise also require protection.
Remember the 3 foot rule:– If you have to raise your voice to talk to
someone 3 feet away, you need hearing protection!
See Table D-2 at 1926.52
19SUBPART
E PPE
Protecting Your Eyes and Face Each day 1,000 workers injure their eyes. Protection is required when machines or
tasks present potential eye or face injury.
Hazards can be physical, chemical, or radiation-related.
Protection must meet ANSI Z87.1– Sunglasses with plastic lens don’t meet the
requirements unless Z87.1.
21SUBPART
E PPE
Types of Eye & Face Protection Safety Glasses-
– Protect eyes from front and side hazards as well as flying particles.
Regular Vented Goggles-– Protect your eyes from dust, sparks, and flying particles.
Hood Vented Goggles-– Protect your eyes from chemicals & dust.
Full Face Shield-– Protects face from splashes, and flying particles.– Must be used with safety glasses or goggles.
22SUBPART
E PPE
Protecting Your Lungs
A respirator is a device which maintains a supply of breathable air.
There are two types of respirators.– Air-Purifying: filters the air.– Supplied-Air: gives you clean air from
another source. Either must be NIOSH- or MSHA-
approved.
23SUBPART
E PPE
Air-Purifying Respirators Use filters which either
absorb the chemical or filter out the particulate.
– Reusable Type• has a filter, cartridge, or
canister• filter, cartridge, or canisters
are labeled with the type of contaminant they protect you from.
– Disposable Respirator• single or multiple use, usually
for dust only.
24SUBPART
E PPE
Supplied-Air Respirators The breathing air comes
through a hose from a compressor, or from a tank.
Connections must be tight and the hose must be protected from damage. Breathing is easier & inward
leakage is less than when using the air-purifying type.
Must be used in high concentrations or where O2 level is reduced.
25SUBPART
E PPE
An Effective Respirator To protect you, a respirator must:
– Be the correct one for the hazard to which you are exposed.
• The “workplace protection factor” must be high enough for the concentration encountered.
• Example: Half-mask protection factor = 10
Provides protection up to 10X the PEL
– Fit you properly. (Fit testing)– Be inspected and maintained, and– Be used according to the manufacturer.
26SUBPART
E PPE
Facemask Types
There are several styles of facemasks.– Half-mask
• Covers the nose and mouth.
– Full Face-mask• Covers nose, mouth, and eyes.
– Air-Fed Helmet• Covers the entire head.
27SUBPART
E PPE
The Employer’s Responsibility
OSHA requires your employer to have a respiratory protection program.
Your employer must:– Provide a medical evaluation to ensure you are
okay to use a respirator.– Choose the proper respirator for the hazard.– Train you in the proper use, limitations, and care
of the respirator. – Fit test you to find a model that fits your face &
has a good face seal.
28SUBPART
E PPE
Respirator Program (cont’d)Where Respirator Use is Not Required
Employer may provide respirators at employee’s request or permit employees to use their own respirators, if employer determines that such use in itself will not create a hazard
If voluntary use is permissible, employer must provide users with the information contained in Appendix D
Must establish and implement those elements of a written program necessary to ensure that employee is medically able to use the respirator and that it is cleaned, stored, and maintained so it does not present a health hazard to the user
Exception: Employers are not required to include in a written program employees whose only use of respirators involves voluntary use of filtering facepieces (dust masks).
Fit is Important Your respirator must seal tightly
against your face. Things which can prevent a good
seal:– beards and sideburns– eyeglasses– the shape of your face; remember;
respirators do come in different sizes.
29SUBPART
E PPE
Fit-Check Your Respirator Perform both types of fit checks every
time you put your respirator on. There are two ways to make sure your
respirator fits properly.
– Positive fit check• Exhale to check for leaks.
– Negative fit check• Inhale to check for leaks.
30SUBPART
E PPE
Positive Pressure Check
Place palm over exhalation valve.
Gently exhale. If face piece
balloons out slightly & you can’t feel leakage, you have a good seal.
31SUBPART
E PPE
Negative Pressure Check
Block ends of cartridges with hands.
Gently inhale. If face piece pulls in
and you don’t feel a leak, then you have a good seal.
32SUBPART
E PPE
Respirator Care
Follow the manufacturer’s directions. Inspect it before each use. Repair or discard it if necessary. Clean it after each use. Store it in a clean plastic bag. Replace cartridges/filters if it’s hard to
breathe or you can taste/smell the chemical.
33SUBPART
E PPE
Protecting Your Feet and Legs Every year nearly 200,000 workers
injure their feet. OSHA requires you to wear foot
protection where there is a possibility of material falling, crushing or rolling over.
Safety shoes must meet the requirements of ANSI Z41.1
34SUBPART
E PPE
Choosing Foot Protection
Look for the ANSI label on the tongue.
Wear sturdy shoes withthick soles, steel toes& steel shanks.
35SUBPART
E PPE
Protecting Your Hands & Body
OSHA has no specific requirements for PPE for hands & body.
Hand/body injury hazards must still be evaluated. Handling caustics, acids,
solvents, adhesives, rough and hot materials without protection is unsafe.
36SUBPART
E PPE
Working Over or Near Water Workers near or over water must wear
a U.S. Coast Guard-approved life jacket or buoyant work vest.
Life jackets must be inspected before each shift and not used if defective.
Ring buoys must be installed with at least 90 feet of line & no more than 200 feet apart.
A skiff must be available.
37SUBPART
E PPE
Case Study: What went wrong?A contract employee was assigned to sandblast the inside of a reactor vessel during turnaround activities at a petrochemical refinery. Instead of relying on the contract company's own air compressors in accordance with the contractor's policy, the contract foreman connected the employee's supplied air respirator to a hose containing what he thought was plant air. It was nitrogen. The employee died.
38SUBPART
E PPE
Is This Adequate Protection?
39SUBPART
E PPE
Subpart E - Personal Protective and Life Saving Equipment
(1926.95 - 107)
994
301
195
122
27
100(a)
102(a)(1)
95(a)
105(a)
106(a)
Standard
- 1
926.
Safety nets for falls over 25 feet
PPE - Provided, used and maintained
Eye and face protection
Life jackets/vests
40SUBPART
E PPE
Head protection required
Always Inspect Before Use!!!
The End