8/6/2019 LO 5-3825-270-13 EMM WD
1/12
Card 1 of 8
LO 5-3825-270-13LUBRICATION ORDER24MAY 2011
ENGINEER MISSION MODULE - WATER DISTRIBUTOR (EMM - WD)NSN 3825-01-577-2713
PN 5251894CAGEC 80195
References: TM 5-3825-270-10 and TM 5-3825-270-23&P
DISTRIBUTION STATEMENT A. Approved for public release: distribution is unlimited.
NOTICE. Copy of this lubrication order will remain with the equipment at all times; instructions contained herein are
mandatory.
REPORTING OF ERRORS
You can help improve this publication. If you find any errors, or if you would like to recommend any
improvements to the procedures in this publication, please let us know. The preferred method is to submit
your DA Form 2028 (Recommended Changes to Publications and Blank Forms) through the Internet, on
the Army Electronic Product Support (AEPS) website. The Internet address is http://aeps.ria.army.mil.
The DA Form 2028 is located under the Public Applications section in the AEPS Public Home Page. Fill
out the form and click on SUBMIT. Using this form on the AEPS will enable us to respond quicker to your
comments and better manage the DA Form 2028 program.
You may also mail, e-mail, or fax your comments on DA Form 2028 directly to the U.S. Army TACOM Life
Cycle Management Command. The postal mail address is U.S. Army TACOM Life Cycle Management
Command, ATTN: AMSTA-LCL-MPP / TECH PUBS, 6501 E. 11 Mile Road, Warren, MI 48397-5000.
The e-mail address is: [email protected]. The fax number is DSN 793-0726 or
Commercial (309) 782-0726. A reply will be furnished to you.
8/6/2019 LO 5-3825-270-13 EMM WD
2/12
LO 5-3825-270-13
Card 2 of 8
LUBRICATION ORDER
NOTES:
This LO is for crew (C) or field (F) maintenance. Lube intervals (on-condition or hardtime) are based on normal
operation. Lube more during constant use, and less during inactive periods.
The water distributor is not designed for use in temperatures below 33 F (0.56 C) or higher than 122 F (50 C),therefore, the same grade lubricants should be used at all time. When using a grease gun, apply lubricant to the
fitting until clean lubricant squeezes out of the part being lubricated.
Clean parts with dry cleaning solvent (SD), type II, or equivalent. Dry before lubricating. Wipe surfaces dry.
Before you start your lube service.
For equipment under manufacturer's warranty, hard time oil service intervals shall be followed. Intervals shall be
shortened if lubricants are known to be contaminated or if operation is under adverse conditions such as longer
than usual operating hours, extended idling periods, extreme dust, etc.
ALWAYS NEVER
a. Clean grease fittings before lubrication. a. Use wrong type/grade grease.
b. Use the lubrication order as your guide. b. Use too much lubricant.
Table 1. Lubricants.
Component
Approximate
Capacity Intervals
EngineOil(E
O):
OE/HDO-3
0
MIL-PRF-21
04
Manhole Cover As Required
OC-ON-CONDITION
D - DAILY
W - WEEKLY
M - MONTHLY
S - SEMIANNUALLY (6 MONTHS)
A - ANNUALLY
B - BIENNIALLY
Stowage Box
Hinge
As Required
Air Lubricator As Required
EngineOil(EO):
OE/HDO-30
MIL-PRF-2104 Water Pump 3 oz
(88.8 ml)
EngineOil(EO
):
15W-
40
MIL-PRF-2104
Engine 14 qts(13.2 L)
8/6/2019 LO 5-3825-270-13 EMM WD
3/12
Card 3 of 8
LO 5-3825-270-13LUBRICATION ORDER
Table 2. Other Fluids.
Fluid Capacity Temperature
Dry Cleaning Solvent As Required All Temperatures
Antifreeze, Ethylene Glycol
(A-A-52624, Type 1B)
14 qt
(13.25 l)All Temperatures
Table 3. Grease, Automotive and Artillery (GAA): MIL-PRF-10924.
The following components are lubricated with GAA as required at all temperatures.
Component
Approximate
Capacity Intervals
Fog Nozzle As Required OC-ON-CONDITION
D - DAILY
W - WEEKLY
M - MONTHLY
S - SEMIANNUALLY (6 MONTHS)
A - ANNUALLY
B - BIENNIALLY
H - HOURS
Hose Reel As Required
Water Turret As Required
Table 4. Total Man-Hours *Required for Service.
Distributor, Water (EMM-WD) Hours
D --
W --
M --
S --
A --
BI --
8/6/2019 LO 5-3825-270-13 EMM WD
4/12
LO 5-3825-270-13
Card 4 of 8
LUBRICATION ORDER
8/6/2019 LO 5-3825-270-13 EMM WD
5/12
Card 5 of 8
LO 5-3825-270-13LUBRICATION ORDER
8/6/2019 LO 5-3825-270-13 EMM WD
6/12
LO 5-3825-270-13
Card 6 of 8
LUBRICATION ORDER
8/6/2019 LO 5-3825-270-13 EMM WD
7/12
Card 7 of 8
LO 5-3825-270-13LUBRICATION ORDER
8/6/2019 LO 5-3825-270-13 EMM WD
8/12
LO 5-3825-270-13
Card 8 of 8
LUBRICATION ORDER
8/6/2019 LO 5-3825-270-13 EMM WD
9/12
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
By Order of the Secretary of the Army:
MARTIN E. DEMPSEY
General, United States Army
Chief of Staff
Official:
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
JOYCE E. MORROW
Administrative Assistant to the
Secretary of the Army
1110302
DISTRIBUTION: To be distributed in accordance with the initial distribution requirements for IDN 257864
requirements forLO 5-3825-270-13.
8/6/2019 LO 5-3825-270-13 EMM WD
10/12
8/6/2019 LO 5-3825-270-13 EMM WD
11/12
8/6/2019 LO 5-3825-270-13 EMM WD
12/12
PIN: 086770-000