Cen-Tech Seven Function Digital MultimeterDial Replacement
This guide will show how to remove and replace the dial.
撰写者: Anna Kihm
Cen-Tech Seven Function Digital Multimeter Dial Replacement
© iFixit — CC BY-NC-SA zh.iFixit.com 1 / 6 页
介绍介绍
If the dial is stuck in any particular position it will be necessary to replace. This guide will show howto locate and replace the dial.
工具工具:Phillips #0 Screwdriver (1)
Flathead 3/32" or 2.5 mm Screwdriver (1)
章节章节:Cen-Tech Seven Function Multimeter
Dial (1)
Cen-Tech Seven Function Digital Multimeter Dial Replacement
© iFixit — CC BY-NC-SA zh.iFixit.com 2 / 6 页
步骤步骤 1 — Position Device
Place the meter face down, so theback panel and screws can be seen.
步骤步骤 2 — Remove Back Panel Screws
Unscrew the two 9mm screws on the back panel using a #0 Phillips screwdriver.
Cen-Tech Seven Function Digital Multimeter Dial Replacement
© iFixit — CC BY-NC-SA zh.iFixit.com 3 / 6 页
步骤步骤 3 — Remove Back Panel
Remove the back panel of thedevice by lifting upward.
Remove the battery from the meterbefore continuing.
步骤步骤 4 — Unscrew Motherboard
Remove the four 7mm Phillips screws holding the circuit board in place.
Cen-Tech Seven Function Digital Multimeter Dial Replacement
© iFixit — CC BY-NC-SA zh.iFixit.com 4 / 6 页
步骤步骤 5 — Remove Motherboard
Gently lift the circuit board awayfrom the device casing.
Remove the battery after removingthe back cover to reduce thechances of short-circuiting the circuitboard.
步骤步骤 6 — Locate Dial
The dial is located in the central partof the device.
Cen-Tech Seven Function Digital Multimeter Dial Replacement
© iFixit — CC BY-NC-SA zh.iFixit.com 5 / 6 页
To reassemble your device, follow these instructions in reverse order.
此文档最后生成于 2018-06-10 05:16:25 AM。
步骤步骤 7 — Remove Dial
Carefully remove dial from device bylifting upward.
Clean existing dial or replace ifnecessary.
Take care not to lose the small ballbearings.
Cen-Tech Seven Function Digital Multimeter Dial Replacement
© iFixit — CC BY-NC-SA zh.iFixit.com 6 / 6 页