Automatic Water Level ControllerWith Voltage Protection
Automatic water level controller with Over/Under voltage protection
mechanism by Avench Systems is a High performance system, Built compactly
to provide advanced features like clear liquid using PWM, Motor ONAuto/
Manual rocker switch, Motor- ON/Reset soft pulse switch, software
based in built low and high voltage cut off, surge protection, dry run protection
and easy smooth operation .The water level controller can switch on or switch
off the pump to maintain the predefined water level at the storage tanks.
FeaturesHigh reliability and Low maintenance
Visual Indications
How It Works
Automatic Water Level controller can be used for a long time,
no maintenance or repairing would be required during its
operational period.
Low voltage PWM sensing circuit to avoid polarization of
electrodes in water. These special made plastic molded
conductive electrodes are long life sensors and do not require
frequent cleaning or replacement
Four LEDs are provided for indicating Power ON (Red),
abnormal voltage (Yellow), Motor ON (Green), and
Dry Run (Amber).
Automatically starts the motor when the water
level in the over head tank drops below a pre-defined level
(that is below low level sensor) and switches off the motor at
full tank(when water reaches high level sensor).
Dry Run
Voltage Cut-off
Surge protection
Soft Pulse switch to Push motor to ON
Need
Rocker Manual Motor ON Switch.
Due to faulty foot valve or air leakage in the pipe if the motor runs dry then it gets
switched off automatically and gives fault indication.
Automatic Water Level Controller with Over / under voltage cutoff technique
automatically switches-off the pump if the supply voltage is not within the safe
limit (160V-275V) and again switch ON the Motor from OFF Condition only
when the voltage reach back to the steady preset safe voltage level.This avoids
relay chattering and switching.
Built in surge protection is the Main feature of the controller.
Automatic water Level Controller comes with this feature of pushing motor to ON
manually and the motor starts running unless water is not full or touches the high
level sensor in tank. Then motor will be switched off automatically once water
reaches the high level sensor.
The Optional Need soft switch is provided to Switch on the motor irrespective of
the water level in over head tank.
The rocker switch is provided to switch ON the motor manually. When this is ON
motor runs continuously irrespective of the level in tank, until it is switched off. So
no need to disconnect the system when it gets failed.
#44, 3rd Cross, Kaggadasapura Main Road, Vignan Nagar, Bangalore 560075, Karnataka, India.
Phone Mob:+919744456186. office:+91-804-2013592, [email protected]
www.avench.com
Application
The product is suitable for almost all site conditions water tank for
maintaining level automatically, can be used to control water inflow or outflow, by
means of direct pump control or acting as a control switch of a starter,
Contactor / Relay.
Suitable for
| | | | | | |
Motors rating up to 2HP. Mono block pump (sump motor) Sump submersible
pumps. Jet Pumps, etc...
Hotels Factories Commercial complexes Drains Homes Apartments