Download pdf - Application Note 100 - Cimarron Technologies Corp CIM-1200 Installation Notes for the Kenwood TK-690/790/890 (For Conventional Use Only) Application Note PROCEDURE: Title: Application

AN: 100 Date: April 6, 2011 Page 1 of 3

Model Number: CIM-1200 ANI Encoder

Description: CIM-1200 Installation Notes for the Kenwood TK-690/790/890

(For Conventional Use Only)

Application Note

PROCEDURE: 1. Prepare CIM-1200

• Install Jumpers V and E. (See Page 2)

2. Program the CIM-1200 • Use the QuikWare Programming Software to make the following changes:

• Set TX Level 40

• Set Key Follows PTT to ‘YES’

• If Sidetone is desired, set PTT Side tone Audio Level to 50

• Set ID, Signaling Format, etc.

• If Emergency function is not desired, do not program IN1 for Emergency

3. Program the radio with KPG-44D as follows: • Go to ‘Model Information’> ‘Option Board’ select ‘ANI Board’.

• Go to ‘Edit’> ‘Optional Features’> ‘Optional Features 2’> ‘PTT ID’>‘ID Format’ select ‘ANI Board’.

• Go to ‘Channel Edit’ check the ‘PTT ID’ box for each channel that you want ANI on.

• If Emergency function is not desired, do not program a key for Emergency

• Go to ‘Edit’> ‘Key Assignment’ and choose the button desired for ‘Emergency Call’.

• Go to ‘Edit’> ‘Emergency Information’ select the Group/ Channel desired for Emergency, and under ‘Emergency Type’ select ‘ANI Board’.

Input / output Function Signal

IN0 PTT Low IN1 EMERGENCY Low OUT0 Key Output High OUT1 Critical Revert High

OUT2 Mic Mute High All Pull-ups = OFF, All debounce = 10mS

AN: 100 Date: March 31, 2011 Page 2 of 3




Application Note

Function Connector CIM-1200

PTT CN508 12 PAD 2 A+ CN508 13 PAD 12 A- CN508 14 PAD 13

DATA CN507 10 PAD 11 TONE CN507 8 PAD 14

Mic Mute CN507 7 PAD 6 Critical Chan CN507 4 PAD 3

KEY CN507 3 PAD 1 EMERGENCY CN507 2 PAD 4

From Step 1:

Jumpers V E

PROCEDURE: 4. Connecting the CIM-1200 to the Kenwood connectors

• Two connectors are required for this install. These connectors are Kenwood part numbers: E37-0809-05 & E37-0808-05.

• Strip 1/16” & tin • Cut unused wires flush with the connector

Note: Kenwood wire colors can vary !

1.5 in

2.0 in

AN: 100 Date: March 31, 2011 Page 3 of 3




Application Note

PROCEDURE: