ADVANCED TRAINING: THE 6525 CONTROL SYSTEM
System Review, Settings, Configuration & Technical Requirements
May 2017 Rev 2
SLIDE 2
AGENDA
• Quick Review of the 6525 Components
• System Functionality & Limitations
• Available Parameters
• Programming the 6525 System
• Options for Configuring Actuators & Microprocessors
• System Alarms
• Hands-On Session: Configuring the 6525 System
SLIDE 3
6525 System
• Applies to a wide variety of applications
• Programmed using a laptop
• Wide variety of control heads, actuators & stations
• Up to 8 stations • Greater cable length
options • Class approved
SLIDE 4
6525 System - Control Heads
6505 6509
6515
6508 6501
6570
7176
6506 6655
6555
6504 6514
SLIDE 5
6525 System - Actuators
6524
6527 6528 6531
6560
SLIDE 6
6525 System - Processors
• 6525 microprocessor runs an entire system
• Multiple outputs
• 6533 Electric Clutch Drive Unit used for electric clutches
SLIDE 7
Telegraph / Engine Alarm Panels
SLIDE 8
6525 Configuration Options
1 to 8 Stations
Control Heads
Any Actuator
1, 2 or 3 Engines
Single or Dual
Functions
6525 Microprocessor
Redundancy
Switches
SLIDE 9
System Functions & Limitations
• Control engines, gearboxes, trolling valves, CPPs, water jets
• Up to 8 stations, mechanical output or electronic output
• Distance between system components up to limits of RS-485 networking
• Water proof depends on control head selection
• Multiple actuators available for different applications
SLIDE 10
Available Parameters
• Control head options & configuration
• Actuators available for the 6525 System
• CPU input/output ports & signals
SLIDE 11
Programming the 6525
• Demonstration of the operation of the system
• Calibration of the system
• Calibrating basic parameters
• Control head calibration
SLIDE 12
Hands-On Session: Configuring the 6525 System
• Build a basic system
• Calibrate the control head
• Calibrate the system timing
• Calibrate the throttle output
• Q&A
SLIDE 13
Thank you!
• Hicham Al-Achkar
• Kirk Richardson
• Ryan Edwards