3D machining 13D machining 1
Contents
Model importModel import
The parts 3D model was imported into the Model folder, fixtures 3D models were imported into the Restrictions folder.
Part model
Folder containing imported model geometry
Import model geometry
Folders containing geometry of imported fixtures
Folders containing geometry of imported fixtures
Fixtures modelsFixtures models
Contents
The workpieceThe workpiece
Workpiece transparent view
Box around Part
The default workpiece is a box, it is built automatically around part.
Contents
The operationThe operation
Create new operation menu
Roughing waterline
Roughing operations group
New Roughing waterline operation
Contents
Roughing waterline Roughing waterline
Contents
Job assignmentJob assignment
Model of the part in the Model folder is automatically added as the operations part
Geometry model of the part
Models of fixtures in the Restrictions folder are automatically added to the restricted area of the operation
Geometry models of fixtures
Contents
Machining parametersMachining parameters
Contents
Machining strategyMachining strategy
Machining is performed by parallel passes
Set pass step to 30% of the tool diameter
Do not use trochoid
Contents
Toolpath calculationToolpath calculation
Toolpath calculation
Toolpath
Marks that the calculation is successful
Contents
Machining simulationMachining simulation
Tool
Workpiece
ИнструментFixtures
Machining result
Остаточный материал под прихватами
Leftover material under the fixtures
Contents
Функция создания операции
Next operationNext operation
Create operation menu
Finishing operations group
Complex
Finishing complex
Finishing Plane
Finishing Plane
Contents
Complex machiningComplex machining
Finishing waterline Finishing plane
Complex finishing
Residual material Residual
material
Minimum residual material
Contents
Job assignmentJob assignment
Par t of the previous operation
When new operation is created its part is set to the part of the previous operation by default. In our example the part is assigned for both member operations of the Finishing complex operation. Fixtures restrictions are not applied to this operation.
Contents
Finishing plane parametersFinishing plane parameters
Contents
Finishing waterline parametersFinishing waterline parameters
Contents
Toolpath calculationToolpath calculation
Toolpath calculation
Toolpath
Indicates that calculation is succesful
Contents
Machining simulationMachining simulation
Tool
Holder
Residual material of previous operation
Turn off “Shade plus Ware” and turn on “Shade”
Machining result
Contents
New operationNew operation
Create operation menu
Roughing operations group
2D contouring
New 2D contouring operation
Contents
Job assignmentJob assignment
Curve selection dialog
Equidistant contour
Job assignment tab
Select curve
Contents
Machining parametersMachining parameters
Contents
Toolpath calculationToolpath calculation
Toolpath calculation
Toolpath
Indicates that toolpath calculation is successful
Contents
Machining simulationMachining simulation
Residual material of previous machining
ToolMachining result
Contents
Tools list creationTools list creation
Create tool list
Tool list dialogView configuration
Object visibility panel
Document template
Contents
Tools listTools list
List of operations
Document template
List of toolsMachining time
Geometry model views
Contents
PostprocessorsPostprocessors
NC-program generation
Postprocessor file
NC-program file name
NC-program listing
Contents