Ultra-tec is Manufactured by:The Cable Connection
Ultra-tec’s Pre-Assembled Cable Railing Kits are manufactured in Carson City, Nevada
1. Space the cables with a 3” opening between cables2. Support cables vertically every 42”3. Tension the cables to 300-400 lbs
4” Sphere Code Guidelines
1013.3 Opening limitations. Required guards shall not have openings which allow passage of a sphere 4 inches (102 mm) in diameter from the walking surface to the required guard height.
International Building Code 2009 (Sixth Printing)
Cable Kit Lengths
BBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBB
First 3 digits represent kit seriesNext 2 digits represent the length of the cableThe -6 represents 3/16” diameter cable
Kit 262 Series Outside Post to Outside PostThis kit can go through one corner with
posts offset on the corner.
Factory Installed Tensioning Hardware
Invisiware Receiver
This Stud is Swaged onto one end of the cable and it threads into the Invisiware Receiver to
tension the cable.