Connection of GAMP 0183 to onboard instrumentation2.1 –7/2015
Gamp Connections
pag 2
INDEX
esa DONGLE Wi-‐Fi general aspects 3H3000 B&G to dongle esa 4
GAMP ESA Wi-‐Fi general aspects 5H3000 B&G 6H3000 B&G 2000 Performance 7H3000 B&G 2000 Display FFD 8H5000 B&G 9-‐10TRIDATA E MULTI ST 50 AUTOHELM 11MULTI ST 60 RAYMARINE 12TRIDATA ST 60 RAYMARINE (RAYMARINE GENERAL) 13Wi-‐Fi RAYMARINE/TakTiCK 15-‐17NEXUS NX2 SERVER 18
pag 3
DONGLE Function Connector/converter Sea Talk
Red +12V Sea Talk red (+12V)Blue GND Sea Talk white (GND)Verde Dati IN RS232 OUT +, o NMEA out
Example of connection between Esa dongle and SeaTalk converter
• esa dongle Wi-‐Fi, is protected against reverse polarity, is not waterproof, it’s easy to be connected to the equipment of the boat, it uses the data in NMEA 0183 format.
• It should be installed in an area where there are no shield for data transmission signal to antenna of the the receiving Apple device. Test the stability of the Wi-‐Fi connection in various positions to before completing the mounting.
• the DONGLE’s output wires have the following functions and connections:
Hardware Wire Function DONGLE To be connected to:Red +12V +12V wiring/instrumentsBlu GND Ground wiring/instrumentsGreen Data IN RS232 OUT +, or NMEA out
• If the instruments uses a different language to NMEA 0183• Translator is required for example for Raymarine and NKE instrumentations
N.B-‐ esa app only works with GAMP esa or esa dongle . It sends data NMEA0183 via Wi-‐Fi.-‐ Di seguito per I collegamenti illustrati al GAMP di Astra Yacht si applicano per il dongle le stesse regole collegando
per il segnale solo il cavo verde e I due cavi di alimentazione
pag 3
esa DONGLE WiFi
pag 4pag 4
H3000 B&G a Dongle esa
CavoDongle Funzione DONGLE Box H3000 B&GRosso +12V Power Term1 (+12V)Blu GND Power Term2 (0 V)Verde Dati IN NMEA out Term 1
NMEA outPower
pag 5
Hardware GAMP functionRed +12VBlue GND/-Green DataIN +Yellow DataIN -
• esaGAMP Wi-‐Fi, is protected against reverse polarity, is not waterproof, it’s easy to be connected to the equipment of the boat, it uses the data in NMEA 0183 format.Note: GAMP does not interfere in any way with onboard instrumentation throug the NMEA IN connection. GAMP is IP54, not waterproof.
• Install GAMP in a place where there is no data transmission shield from the antenna to receiver apple device.Please test range and connection stability before final installation
•GAMP out wires have the following functions:
WARNING: If the instruments on board using a protocol other than NMEA 0183, you must use a "translator";It will be necessary, for example, for instrumentation and Raymarine NKE, or in case the instrumentation is NMEA 2000.
Sometimes the Wi-‐Fi transmission may disturb the GPS, if the GAMP Wi-‐Fi is positioned in the vicinity of the GPS antenna: check and possibly remove the two devices together, 1 meter of separation is generally sufficient.
pag 5
GAMP ESA Wi-‐Fi
pag 6pag 6
H3000 B&G to Gamp nmea 0183 esa
NMEA outPower
pag 7
Blue 12V -Red 12V +Yellow NMEA -Green NMEA +
H3000 B&G 2000 Performance: is providedwith NMEA 0183
Pg 4-15 manuale
pag 8
Connect together yellow and blue Gamp to ground.
H3000 B&G 2000 Display FFD : is provided with NMEA 0183
Pg 4-18 manuale
Blue (GND) and Yellow (NMEA –) Red (+12V)
Green (NMEA +)
pag 9
H5000 B&G 1/2
pag 10
Power NMEA out
H5000 B&G 2/2
pag 11
TRIDATA E MULTI ST 50 AUTOHELM
Ref to link internet: http://www.raymarine.com/view/?id=1964&collectionid=13&col=3458
Pg 9 manual ST 50 Plus Multi, ground connection not required
Pg 17 manuale ST 50 Tridata,ground connection not required
pag 12
MULTI ST 60 RAYMARINE is providedwith NMEA 0183
ST 60 Multi connessione al GAMP
Pg 8 and pg 24 manual MULTI ST 60
pag 13
TRIDATA ST 60 RAYMARINE
Ref to internet NMEA0183 Accessories: http://www.raymarine.com/view/?id=5534&collectionid=23&col=4530
The instrumentation tridata Raymarine ST 60 has no connection NMEA,You must connect to a connector sea to talk NMEA 0183
pag 14
TRIDATA E MULTI ST 60 RAYMARINE: ref to Raymarine manual
link: http://www.raymarine.it/view/?id=1964&collectionid=13&col=3457
pag 15
Gamp 0183-esaMultiplexer wi-fi
For example
Esa pro
Wi-‐Fi RAYMARINE/TakTiCK: system architecture connection to esa
pag 16
Raymarine7/TackTic Wireless T122 MicronetWireless interface
pag 17
Gamp 0183-esaMultiplexer wi-fi
Esa pro
Raymarine Wireless T122 Micronet Wireless interface
pag 18
The Nexus NX2 server has a connection 0183:
•For power you can connect the GAMP to pins 1 and 2 of the server: connect the Connector1 server with Power + of GAMP and the connector 2 with Power -
The signals for the NMEA 0183 connect connector 3 server with port NMEA1 in the GAMP terminal +, and the connector 4 server with NMEA1-
NEXUS NX2 SERVER
ASTRA YACHT SRL- PIAZZA DELLA REPUBBLICA 15 - 34074 MONFALCONE (GO) ITALY - TEL. +39 335 1047207 - [email protected] - WWW.ASTRAYACHT.COM
E A S Y H I G HT E C H N O L O G Y