ZA-5000 Upgrade Guide
Nanjing Z-Com Wireless Co.,Ltd.
NOTE1: This is only for upgrading F/W from upwards of 1.0.6
(excluding 1.0.6) to 2.0.3 of ZA-5000 series product of Nanjing
Z-com Wireless Co., Ltd.
1. Log in IE, Check the version NO.2. Click Backup/Restore, to
set ZA-5000 to factory default settings.
3. Re-login IE (192.168.0.228), Click Firmware Upgrade.4. In
page of upgrade firmware, press Browse:
Choose the rmt file named ZDC ZA-5000 FW2.0.3.rmt,Open it:Then
press Upload:The ZA-5000 will reboot automatic, please wait for 3
minutes to take effect!
5. Logging in again (192.168.0.228), check version No.!6. After
upgraded successful, Click Backup/Restore, to set ZA-5000 to
factory default settings.
Congratulations, You had completed upgrade successful! Enjoy
it!Note2: This is only for upgrading F/W from downwards of 1.0.6
(including 1.0.6) to 2.0.3 of ZA-5000 series product of Nanjing
Z-com Wireless Co.,Ltd.1. Under Windows, run Command Console
Application:Start -> RunWindows 98 ,Type command.com;Above
Windows 98,Type cmd.exe;To rum Command Console Application
2. Key in ftp X.X.X.Xthe X.X.X.X is the IP address for ZA-5000
which is configured(Not Default IP Address),then key in username
(admin) and password (Default is : password )
3. Key in put e:\ZA5000.rmt.Make sure that the file named ZDC
ZA-5000 FW2.0.3.rmt has to be re-named to ZAG5000.rmt e:\is the
path which file ZAG5000.rmt located;
4. Please wait for 3 minutes after finishing upgrading.5. After
rebooting, Logging in again (Not Default IP Address), check version
No.!6. After upgraded successful, Click Backup/Restore, to set
ZA-5000 to factory default settings.
== CONFIDENTIAL (All right reserved by ZDC) ==2
