Upload
others
View
3
Download
0
Embed Size (px)
Citation preview
Yamaha R12007-2008
Remove the main seat.Remove the black fuel tank covers.
Remove the fuel tank.
www.healtech-electronics.com
S U P P L E M E N T A R Y M A N U A Lfor QSE-1 + QSH-P4A
PAGE 1/3
Remove the airbox.
Remove the voltage regulator with the plastic holder.
Yamaha R12007-2008
www.healtech-electronics.com PAGE 2/3
Plug QSH connectors in-line with the ignition coil
connectors.(black, 2-pole connectors below airbox)
Connect QSH black wire terminal to chassis ground.
Mount the QSE sensor.(Use the new bolt and washers supplied with
the unit. Make sure to place one washer above the sensor and one washer below the sensor.
tighten the screw by 3-4 Nm.
When tightened, do not try to rotate the sensor body.)
Yamaha R12007-2008
www.healtech-electronics.com PAGE 3/3
Typical position for theQuickShifter Easy.