Embed Size (px)
Citation preview
INTRODUCTIONXPROG-m Errata Sheet 001
This errata provides information applicable to the following products:● 1-002-0017 programming adapter Rev.B or earlier
These changes allow you to work with secured ARM MCU via JTAG interface
STEP1
Remove this resistor
STEP2
● Prepare the four wires. About 5cm in length.
1A
2A
3A
4A
1B
2B
3B
4B
1A
3A
2A 4A
STEP3
● Solder wire shown in the corresponding points at the bottom side
2B
3B
4B1B
STEP4
● Solder wire shown in the corresponding points at the top side
www.diyobd.fr
Email: [email protected] MSN: [email protected]
Yahoo: [email protected] Skype: diyobd.fr
