Embed Size (px)
Citation preview
www.nuuo.comTrusted Video Management
NUUO Bridge Remote Setting
www.nuuo.comTrusted Video Management
Overview• NUUO Bridge Remote introduction
• Remote Access : Domain
• Remote Access : Workgroup
www.nuuo.comTrusted Video Management
NUUO Bridge Remote Introduction Step :
•1.Start up the Bridge for v 1.0.2
•2. Press Settings and select remote
•3.There are two types for remote connection:
• Domain
• WorkGroup
www.nuuo.comTrusted Video Management
Remote Access : Domain• When select Domain for remote access to Lenel Onguard , you only need to
enter the IP only .
• Please follow the instructions :
• 1) Start > Right Click Computer >Properties
• 2) Click Advanced System Settings on the left
• 3) Go to the Computer Name tab
• 4) Click Change next to “Rename this computer etc “
• 5) Check the box for Domain , not Workgroup . Type your domain name then press OK.
• Note :You might have to enter the details of an Administrator account and you will have to restart the computer .
www.nuuo.comTrusted Video Management
Domain : System Setting
www.nuuo.comTrusted Video Management
•Domain :Domain name Change
www.nuuo.comTrusted Video Management
•Domain: Log in with AD Username/Password
www.nuuo.comTrusted Video Management
•Remote Access : Workgroup• When select Workgroup for remote access to Lenel Onguard , you need to
enter the IP & username / Password
• Please follow the instructions :
• 1) Start > Right Click Computer >Properties
• 2) Click Advanced System Settings on the left
• 3) Go to the Computer Name tab
• 4) Click Change next to “Rename this computer etc “
• 5) Check the box for Workgroup . Type “Workgroup “ then press OK.
www.nuuo.comTrusted Video Management
•Workgroup : System Setting
www.nuuo.comTrusted Video Management
•Workgroup : Change name
www.nuuo.comTrusted Video Management
FAQ
www.nuuo.comTrusted Video Management
•Remote Onguard Configuration requirement• 1) Allow WMI pass Windows Firewall
• Close Windows Firewall directly
• Refer to the link below for section 「 In Windows Firewall, ...」：• http://www.sitepoint.com/php-wmi-dig-deep-windows-php/
• 2) Query Device successfully ， but can not connect to OnGuard
• Refer to the link below for section : 「 To grant DCOM remote access permissions」
• http://msdn.microsoft.com/en-us/library/aa393266
www.nuuo.comTrusted Video Management
Thank you!
