[ See Addendum for more information on Reconditioned Engines ]

Addendum:From time to time there were additions, deletions, and

corrections to the Workshop Manual. The following notes

will detail some of these changes. Notice that when certain

Sections were added or deleted the Section numbers couild

change.

Section A.26 - last paragraph:Issues 1 and 2 of the Manual had an error noting that crankshaft

thrust washers, should be installed with oil grooves TOWARD

the bearing. This copy (Issue 3) has corrected this error, noting

the thrust washers should be installed with oil grooves AWAY

from the bearing (toward the rotating flange of the crankshaft).

Refer to Confidential Service Memrandum MG-416.

Section A.29 - from prior issues:This section was printed in prior issues but was not included

in Issue 3:

Section A.44 - from prior issues:This section was printed in prior issues but was not included

in Issue 3: