Upload
others
View
2
Download
0
Embed Size (px)
Citation preview
Disassembling Panasonic GU87 Main-LCDHow to remove the main LCD
Written By: Van
Disassembling Panasonic GU87 Main-LCD Draft: 2019-07-28Guide ID: 3412 -
This document was generated on 2019-09-17 07:05:03 PM (MST).
© iFixit — CC BY-NC-SA www.iFixit.com Page 1 of 6
TOOLS:Tweezers (1)Tri-point Y0 Screwdriver (1)iFixit Opening Tools (1)
Disassembling Panasonic GU87 Main-LCD Draft: 2019-07-28Guide ID: 3412 -
This document was generated on 2019-09-17 07:05:03 PM (MST).
© iFixit — CC BY-NC-SA www.iFixit.com Page 2 of 6
Step 1 — LCD Cover removal
Remove the four rubber screwcovers from encircled locations.
Using a #0 tri wing screwdriver,remove the screws previouslyhidden below the rubber covers.
If you have difficulties finding thisscrewdriver, it is commonly sold as aNintendo Gameboy/Wii screwdriver.
Step 2
Pry the case open using iPhone tool(as shown), fingernails, smallflathead screwdriver, etc.
Be mindful of location andmagnitude of applied force, so asnot to damage the case.
Disassembling Panasonic GU87 Main-LCD Draft: 2019-07-28Guide ID: 3412 -
This document was generated on 2019-09-17 07:05:03 PM (MST).
© iFixit — CC BY-NC-SA www.iFixit.com Page 3 of 6
Step 3 — Minor-LCD
Unlock the minor LCD connector byapplying bilateral pressure withtweezers, as shown.
Step 4
Use fingernails to pry off minor LCDmount, as shown.
Remove the minor LCD
Disassembling Panasonic GU87 Main-LCD Draft: 2019-07-28Guide ID: 3412 -
This document was generated on 2019-09-17 07:05:03 PM (MST).
© iFixit — CC BY-NC-SA www.iFixit.com Page 4 of 6
Step 5 — LCD main board
Unlock the LCD main boardconnectors shown in red boxes onthe picture .
Use tweezers as necessary.
Step 6
Place finger nails on the connectortab as shown.
Lift the connector tab up.
Disassembling Panasonic GU87 Main-LCD Draft: 2019-07-28Guide ID: 3412 -
This document was generated on 2019-09-17 07:05:03 PM (MST).
© iFixit — CC BY-NC-SA www.iFixit.com Page 5 of 6
To reassemble your device, follow these instructions in reverse order.
Step 7
Pull/pivot the LCD main board asshown in order to remove.
Step 8 — Disassembling Panasonic GU87 Main-LCD
Use tweezers to lift up the mainLCD.
Disassembling Panasonic GU87 Main-LCD Draft: 2019-07-28Guide ID: 3412 -
This document was generated on 2019-09-17 07:05:03 PM (MST).
© iFixit — CC BY-NC-SA www.iFixit.com Page 6 of 6