FACULTY OF ENGINEERING SCIENCES AND TECHNOLOGYHamdard Institute of Engineering & Technology

Hamdard University

Name: ___________________________________________________

Roll number: _______________________________________________

Date: _____________________________________________________

Subject: ____________________________________________________

Semester/Section: ___________________________________________

Obtained Marks: _____________________________________________

1. Marking gauge is used to draw the :a) Parallel linesb) Perpendicular linesc) Inclined linesd) All of these

2. One end of try square is fixed at :a) Right angle b) Triangle c) Squared) Rectangle

3. The cutting edge of rip saw makes a steeper angle at about:a) 600

b) 450

c) 300

d) 150

4. In case of cross cut saw, the correct angle for cross cutting is :a) 450

b) 600

c) 300

d) 150

5. The sloping face of a firmer chisel is at angle of :a) 150 -52 0

b) 300-67 0

c) 450-72 0

d) 600-87 0

6. For flat work ___________ File is used:a) Flat file b) Round file c) Circular file d) All of these

7. Vernier caliper is used to measure :a) External dimensions

FACULTY OF ENGINEERING SCIENCES AND TECHNOLOGYHamdard Institute of Engineering & Technology

Hamdard University

b) External diameterc) Depth of hollow shaftsd) All of these

8. In micrometer we are measuring the least round in :a) 0.01 mmb) 0.001mmc) 0.1 mmd) None of these

9. Scriber is used to mark: a) Linesb) Graphsc) Measurement d) None of the above

10. Thermit welding is a process in which weld is affected by pouring:a) Super heated liquid thermit around the partsb) Super heated gas thermit around the partsc) Super cooled liquid thermit around the partsd) Super cooled gas thermit around the parts

Tick the correct answer:

11. In filling process, files of different shapes are used. (yes/no)12. The files are classified according to cut of teeth (single cut, double cut). (yes/no)13. Drilling is the process of making the round holes in metallic plates. (yes/no)14. Reaming is the process of enlargement of existing holes. (yes/no)15. The process of making internal threads by using tapes is called tapping. (yes/no)

Fill in the blanks:

16. A _____________________________ type of striking tool is used driving chisel.17. Hollow planers are used for obtaining ______________surfaces on the wood and _____________

surfaces are obtained through round planer.18. Chisels are used for ___________ and ___________ the wood accurately.19. Carpentry vice is the common _____________ holding device.20. The front portion of saw is called ______________ and back as _________________