Upload
lucy-hubbard
View
231
Download
3
Embed Size (px)
Citation preview
04/19/23 18:16
with Barcode Reader
Selection of barcode reader
1a.
Select the button „Configuration“.
04/19/23 18:16
with Barcode Reader
1b.
Click in the area which is coloured green in the drawing.
This is the base configuration area.
04/19/23 18:16
with Barcode Reader
1c.
Click the check box „Barcode reader“, so that it is checked.
Hint:With „Barcode reader“ checked the „Edit mode“ box within the „Create Order Files“ window is hided. The barcode reader reads the ID and type. Manual input is not necessary.
04/19/23 18:16
with Barcode Reader
1d.
Check the Barcode reader serial port.
Hint:In this example the cable is connected with Com Port 2.
Click „OK“.
04/19/23 18:16
with Barcode Reader
Destination Selection Mode
2a.
Select in the menu „Edit settings“.
In the next screen we distinguish two cases:
Case 1: Working with automatic destination assignment.
Case 2: Working with manual destination assignment.
04/19/23 18:16
with Barcode Reader
Case 1: Working with automatic destination assignment:Click the box, so that it is unchecked.Enter the matrix type.
WD6216
WP24211
WH12@1MM209B 209B@209B
WH12@WH12DS209 209@209
WH12WH12@WH12DR
205MI
854B668
205
853B853B@209
203
526B526B@209B
202
348B 201
306B 200
304B
Rack/WellplateType on Barcode
(.........# )
Case 2: Working with manual destination assignment:Click the box, so that it is checked.
04/19/23 18:16
with Barcode Reader
Start Automation
• Initializing / Home seeking
• Reading barcodes
• Create orders without SampleTrack
• Verify orders
• Preparation
3a.
Click the green button to start automation.
04/19/23 18:16
with Barcode Reader
3b.
The program asks, if the barcodes should be read. Click „Yes“, if you run the program in a new setting.
04/19/23 18:16
with Barcode Reader
Case 1: Working with automatic destination assignment
The destination checkbox is hided and the destination is defined by program.
Case 2: Working with manual destination assignment
The destination must be selected.
04/19/23 18:16
with Barcode Reader
4a.
Case 1: Working with automatic destination assignment:
• Select the source tubes with a lasso operation:
• Click and hold the left mouse cursor. Draw a rectangle.
• The marked positions will be shown as orders.