What is a contour map and how do I

read it??

What is elevation?

• Elevation is the height of a geographic location above sea level.

• Political maps, climate maps, and road maps do not give a clear picture of the elevation of an area of land.

• A contour map uses CONTOUR LINES to indicate areas of steep terrain and areas of flat terrain.

What is a contour line?• Contour lines are lines drawn on a map connecting

points of equal elevation. • If you walk along a contour line you neither gain

or lose elevation.  

QuickTime™ and aTIFF (Uncompressed) decompressor

are needed to see this picture.

• Picture walking along a beach exactly where the water meets the land.

• The water surface marks an elevation we call sea level, or zero.

• The contour line represented by the shoreline separates areas that have elevations above sea level from those that have elevations below sea level.

QuickTime™ and aTIFF (Uncompressed) decompressor

are needed to see this picture.

• We refer to contour lines in terms of their elevation above or below sea level. In this example the shoreline would be the zero contour line.

•It could be 0 ft., 0 m, or something else depending on the units we were using for elevation.  

How are contour lines drawn?• Contour lines are useful because they allow us to show the shape

of the land surface on a map.  • The two diagrams below illustrate the same island. • The diagram on the left is a view from the side.  • The diagram at  right is a view from above (map view) such as

you would see from an airplane flying over the island.• The shape of the island is shown by location shoreline on the

map.  Remember this shore line is a contour line.  It separates areas that are above sea level from those that are below sea level. 

QuickTime™ and aTIFF (Uncompressed) decompressor

are needed to see this picture.

How do we read the contour lines?

• The shoreline will always be at sea level, or 0.• The lines are drawn on the map at set intervals, or

spaces. These are imaginary lines! The only REAL line is the shore line.

• What is the interval on this map?– 10!

QuickTime™ and aTIFF (Uncompressed) decompressor

are needed to see this picture.

• Point A = 0 ft – Point A sits right on the 0 ft contour line.  Since all points on this line have an

elevation of 0 ft, the elevation of point A is zero.

• Point B = 10 ft – Point B sits right on the 10 ft contour line.  Since all points on this line have an

elevation of 10 ft, the elevation of point B is 10 ft.

QuickTime™ and aTIFF (Uncompressed) decompressor

are needed to see this picture.

• Point C ~ 15 ft.– Point C does not sit directly on a contour line so we can not determine the elevation

precisely.  – We do know that point C is between the 10ft and 20 ft contour lines so its elevation

must be greater than 10 ft and less than 20 ft.  – Because point C is midway between these contour lines we can estimate the elevation is

about 15 feet.

QuickTime™ and aTIFF (Uncompressed) decompressor

are needed to see this picture.

• Point D:

• Point E:

QuickTime™ and aTIFF (Uncompressed) decompressor

are needed to see this picture.

Find the elevations of points D and E

How can we use a contour map to help plan a hike?

• The map shows us the elevation of specific points on the map.

• Beginner hikers might want to take the route that is the least steep.

• More adventurous hikers might want to take a steeper route!

• You can tell how steep a hill or mountain is by how close together the lines are on the map.

• The closer the lines, the faster the elevation increases!