Upload
vanjabrnobic
View
230
Download
0
Embed Size (px)
Citation preview
8/4/2019 Wet Room Guide
1/2
Step by Step Guide to Fitting a Wet Room over a Timber FloorThe construction of a wet room is simple and surprisingly low cost.
Before starting work check there is room for the drain and sufficient fall for the waste. Markwhere the Showerlay tray will be fitted. Cut and remove the wooden flooring to expose the joists.
Please also refer to the sectional drawing which is available to viewwww.TileFixDirect.com/pdf/showerlay-installation.pdf
1) The Showerlay tray needs to be
fully supported. Loose fix a level timbersurface between the exposed joistsby fixing battens to the joists. Check
the floor is level in all directions.
3) Cut a hole using the fitting tem-plate supplied (also available fordownload at www.TileFixDirect.com/
pdf/showerlay-installation.pdf
2) Loose fit the Showerlay tray. Thetray may be cut to fit where the tray
abuts walls or boxing in. Mark out thedrain position on the floor.
5) Using a 10 x 10mm floor trowel
spread a polymer modified cementbased adhesive onto the floor and lay
the Showerlay tray into the adhesivebed. The adhesive should make100% contact with tray and floor.
Check the tray is level in all directions.
4) Position the Dallmer drain baseand seal so it will fit flush with the
aluminium base of the Showerlaytray. Ensure everything lines upcorrectly. Connect the pipework to
the Dalmar drain using a solvent weld.
6) Screw the 38mm plastic ringthrough the Showerlay into theDalmer drain making sure the rubber
backing ring is in position. Use theblack tool provided to screw the plasticring as tight as possible. Leave the
tool in place during tiling and grouting.
8) Run DOW Corning Silicone Sealantalong edge of tile backer board andalong floor. Slide the next board into
the silicone. Ensure the joint is fullysealed.
7) Fit tile backer boards to studwork(or glue and screw to plaster finish)
with SUPA PRO stainless steelscrews and SUPA PRO tile backerboard washers.
9) Fix Marmox self adhesive scrimt ap e a lo ng b oa rd j oi nt a nd
in to in ternal corners.
8/4/2019 Wet Room Guide
2/2
Close up showing tiling and Showerlay tray cut away to show all the layers.
0845 050 93 83
www.TileFixDirect.com
*If the Showerlay tray
is one of the 20mmthick trays use ArdexAF200 acrylic adhesiveto fix GMAT. If the trayis one of the 24mmthick trays fi t theGMAT with a polymermodified cement based
adhesive using a 10 x10mm trowel.
AQUAPRO
Glass Shower Screens
now available
11) To the rest of the floor fit
GMAT matting*.
10) Run a skim coat of cement basedadhesive over the scrim tape. This
re-enforces the joint.
12) Fix Ardex WPJ WaterproofingJointing Kit to the perimiter of the
shower tray/wall junction. Use atrowel to ensure all air pockets areremoved.
13) Fit tiles or mosaics to Showerlay
tray using a suitable polymer modifiedcement based adhesive.
14) Remove the black plastic tool,place the hair trap and white funnel in
the drain and position the stainlessgrill.