Upload
jose-rosales
View
219
Download
0
Embed Size (px)
Citation preview
8/3/2019 WEG Us Energy Legislation
http://slidepdf.com/reader/full/weg-us-energy-legislation 1/15
EISA 2007
Energy Independence and Security Act 2007
And New Small Motor regulation
A Motor Perspective
December 2010
8/3/2019 WEG Us Energy Legislation
http://slidepdf.com/reader/full/weg-us-energy-legislation 2/15
Motors | Automation | Energy | Coatings
NEMA Efforts
•
NEMA publishes a summary of the areas of impact for theEnergy legislation on the Electrical industries.
• http://www.nema.org/gov/energy/Energy-Legislation.cfm
• 2005 (Page 4 is motors)
• 2007 bills (See appendix II)
•
Original EPAct 10 CFR Part 431 • http://ecfr.gpoaccess.gov/cgi/t/text/text-idx?c=ecfr;sid=305e4d871e37ab4506f0b66ea184e93e;rgn=div5;view=text;node=10%3A3.0.1.4.17;idno=10;cc=ecfr
8/3/2019 WEG Us Energy Legislation
http://slidepdf.com/reader/full/weg-us-energy-legislation 3/15
Motors | Automation | Energy | Coatings
Energy Legislation Summary
• Original Legislation – EPAct 1992
• The 2005 bill made the purchase of NEMA Premiummotors mandatory for government buildings in an attemptto show leadership in saving energy.
• The 2007 bill raised the level of all product covered in the
original bill to the NEMA Premium levels with theexception of Fire Pump motors (Due to low run hours)Effective December 19, 2010
• The 2007 bill also tried to plug the holes of the original billby expanding coverage
All ratings that are covered by the expanded coverage willonly be require to meet NEMA Table 12-11 which is theEnergy Efficient (Old EPAct) levels.
8/3/2019 WEG Us Energy Legislation
http://slidepdf.com/reader/full/weg-us-energy-legislation 4/15
Motors | Automation | Energy | Coatings
2007 EISA Enhancements
• General purpose electric motor (subtype I) – any electric
motor incorporating the design elements of a generalpurpose…
• Previously covered products (Including XP) increaseto NEMA Premium ® (except fire pump motors)
• Electric motor (subtype II) increase to NEMA MG1 Table
12-11 that are configured as:
• U-Frame motor
• Design C motor
• Close-coupled pump motor
• Footless motor
• Vertical solid shaft normalthrust motor (tested in ahorizontal configuration
• 8-pole motor (900 rpm)
• Polyphase motor with voltageno more than 600 volts (otherthan 230 or 460 volts which
moved to NEMA Premium)• LV Design B (Not A or C)Motors to 201HP - 500HP
8/3/2019 WEG Us Energy Legislation
http://slidepdf.com/reader/full/weg-us-energy-legislation 5/15
Motors | Automation | Energy | Coatings
Is My Motor Covered???• Brake Motors - Maybe
• Appendix A to Subpart B of Part 431—Policy Statement for ElectricMotors Covered Under the Energy Policy and Conservation Actprovides the following guidance. According to the examples of manycommon features or motor modifications that illustrate how the EPCAdefinitions and DOE guidelines would be applied to motor categories:
General Purpose; Definite Purpose; and Special Purpose, a motorwith an integral brake design that is factory built within
the motor is considered a special purpose motor andtherefore not covered. (Otherwise, a motor with a brakeattached (removable) is still considered a generalpurpose motor and therefore covered.)
• Multi-Voltage like 208-230/460 - Yes
• Must meet table 12-11(EPAct) at 208V and Table 12-12
(NEMA Premium) at 230 and 460V. Example from 10 CFRPart 431 ―For example, a motor that is rated at 220 volts should operate successfully on 230 volts, since 220 + .10(220) = 242 volts.A 208 volt motor, however, would not be expected to operate successfully on 230 volts, since 208 + .10(208) = 228.8 volts.”
8/3/2019 WEG Us Energy Legislation
http://slidepdf.com/reader/full/weg-us-energy-legislation 6/15
Motors | Automation | Energy | Coatings
Is My Motor Covered???
• Special Customer defined Flange: - No• While NEMA C & D as well as IEC equivalents are covered,
Special Customer flanges are not covered and the motorsare not required to meet EPAct (or EISA)
• What about Verticals?? - Some• Hollow Shaft – Not covered only Solid Shaft added by EISA
• P-Base solid shaft (HP, LP..) – Only covered if ―NormalThrust‖
• Special Shaft motors (Typically TZ, TCZ, TDZ,TY,LPZ...) - No
• These motors are not considered ―General Purpose and are
not covered.
• 201HP-500HP Design A or Medium Voltage – No• MV not covered in General Purpose definition.
• Only NEMA Design B is covered on 201-500HP
8/3/2019 WEG Us Energy Legislation
http://slidepdf.com/reader/full/weg-us-energy-legislation 7/15
Motors | Automation | Energy | Coatings
Is My Motor Covered???
•
―Inverter Duty‖ – Motors listed for VFD capability• Yes if – the motor is also suitable for general
purpose use on 60Hz sine wave powerTypical example is a Des A or B motor that canstart across the line, but has a MG1 Part 31
VFD capable insulation and is labeled ―Inverter Duty‖
• No if – the motor has a special windingoptimized for VFD service and can not be usedacross the line. i.e. Vector Duty motors that may
have excessive staring current or insufficientstarting torque when started across the line
8/3/2019 WEG Us Energy Legislation
http://slidepdf.com/reader/full/weg-us-energy-legislation 8/15
Motors | Automation | Energy | Coatings
What about Motors for Export
•
WEG can manufacture and import motors that donot comply with the regulation, if they arespecifically marked as:―Export only, Not for installation in the US‖
• Orders must specifically reference this requirement,and these will be entered on the plants requiring thisnote on the motor and Packaging
• No special tracking of the motors is required to
prove they were exported, but penalties will besevere if these motors are found installed in the US
8/3/2019 WEG Us Energy Legislation
http://slidepdf.com/reader/full/weg-us-energy-legislation 9/15
Motors | Automation | Energy | Coatings
Penalties
•
What is the penalty based on?• Improper labeling i.e. Lack of CC# or Efficiency
• Not meeting efficiency level
• Publishing catalog without required info (CC#)
• Failure to provide samples for Gov’t test-No Charge
• Failure to allow access to Documents
• Penalty $110/violation/day
• Penalty is at discretion of DOE and may be reduced
or waived if DOE chooses based on evaluation.
8/3/2019 WEG Us Energy Legislation
http://slidepdf.com/reader/full/weg-us-energy-legislation 10/15
Motors | Automation | Energy | Coatings
What next
• Working with advocacy groups such as ACEEE (American Council forand Energy Efficient Economy) and ASE (Alliance to Save Energy) topromote Energy Efficiency incentives and programs.
• Two Energy Bills currently in Congress contain incentive programs WEGand NEMA have promoted to encourage the early switch to NEMAPremium and the replacement rather than repair of older inefficientmotors. -These bills do not look like they will pass
• New Efficient technology bill in congress $125/HP PM, ECM..• DOE reevaluating Efficiency levels for further increase • Energy advocates pushing to move exceptions to NEMA Premium
What can we do? • You and customers can contact representatives to support the Replace
Vs Repair legislation if it still exists.• Inventory installed base at customers facilities to be ready to take
advantage of incentives or to just make good repair Vs replace decisions
in the future.
8/3/2019 WEG Us Energy Legislation
http://slidepdf.com/reader/full/weg-us-energy-legislation 11/15
Motors | Automation | Energy | Coatings
Small AC Motor Efficiency Regulation• On Feb 28, 2010 the DOE has also mandated efficiencies of General
Purpose Small motors.• This regulation will go into effect 2015• Covered motors are defined as:
• 1/4 to 3HP• ODP• 3-phase, and single phase CSCR and CSIR• 2 Digit Frames 42, 48, 56 and IEC equivalent
• Issues NEMA sees-• Size change impact OEM’s • Size change impact MRO replacements• Setting Efficiency level where no Rating /Frame standard exists• Questionable data in baseline study• Overestimate of operating hours for justification• http://www1.eere.energy.gov/buildings/appliance_standards/commer
cial/small_electric_motors.html
8/3/2019 WEG Us Energy Legislation
http://slidepdf.com/reader/full/weg-us-energy-legislation 12/15
Motors | Automation | Energy | Coatings
Global Regulations
Efficiency Levels Efficiency Classes
IEC 60034-30
Global 2008
Testing Standard
IEC 60034-2-1
2008
MEPS Adopted in TheseCountries
Standard IE1 All Brazil
China
Costa Rica
Israel
Taiwan
High Efficiency IE2 Mexico
AustraliaNew Zealand
Brazil 2009
China 2011
Europe 6/2011
Korea 2008
Premium Efficiency IE3 USA 2011
Canada 2011Europe Jan 2015 7.5kW+
Europe Jan 2017 .75kW+
Above-PremiumEfficiency
IE4 None
8/3/2019 WEG Us Energy Legislation
http://slidepdf.com/reader/full/weg-us-energy-legislation 13/15
Motors | Automation | Energy | Coatings
Is WEG Ready?
•
As one of the largest industrial motor manufacturers in theworld, WEG is ready and pushing for early adoption ofNEMA Premium or greater motors by customers to saveenergy –
• WEG has a complete line of NEMA Premium productstoday and has the capacity to meet the 2010requirements today.
• WEG is currently introducing a new low voltage motorplatform (W22) that was developed to optimize thedesigns around the NEMA Premium motors, and offereven higher efficiencies in the future.
• WEG’s North American manufacturing facilities arecurrently being optimized for the production of NEMA
Premium motors.• WEG EISA Cert # is the same as EPAct CC# 029A
8/3/2019 WEG Us Energy Legislation
http://slidepdf.com/reader/full/weg-us-energy-legislation 14/15
Motors | Automation | Energy | Coatings
Are You Our Customers Ready
• Deadline is December 19, 2010
• Your drawings have part #’s for EISA compliant products.
• Third party certifications on your products include EISAcompliant motors.
• You have a plan to convert inventory. (You can still sell Pre-EISAmotors if they were produced or imported prior to 12/19/2010,
but some customers may not want them.)• You have completed product performance testing with EISA
compliant products.
• Have you partnered with a motor manufacturer that understandsthe 2010 EISA requirements and is prepared to help you getready?
If you are seeing this presentation you have found one.
WEG – Transforming Energy into solutions
8/3/2019 WEG Us Energy Legislation
http://slidepdf.com/reader/full/weg-us-energy-legislation 15/15
Motors | Automation | Energy | Coatings
Thank You
Dale Basso – Motors Manager WEG Electric CorpVice Chairman NEMA Motor / Generator SectionPhone: (678)534-4667E-mail: [email protected]