Week one grasshopper task

Yangyang He 367353

1: line

2: curve

3: square

4: circle

Week 2 Grasshopper task

1. At the beginning, I just want to try the mesh tool which can create natural shape as the video said

2. This is the mesh that I create from the original shape which I think is natural

3. I was exploring the contour tool. And I am just wondering whether it can achieve the goal or not

4. Because the hole in the middle is too small, I mistakenly create the curve that bigger than the mesh, which I found out is wrong…

5. I was trying to change the original object which has a bigger hole in the middle in the mesh

6. At this moment I finally found out that there is no tool in the grasshopper that can intersect a brep with a mesh

7. This is the problem that I face, then I trying to search from the internet about how to transfer a mesh to brep, and it is really complex and not good result for my mesh

8. Then I decide to create another brep from rhino that can intersects with the sections

9.Finally, this time I finished it. I think this is difficult for me since I not that familiar with rhino, but I am keep practicing .