Upload
others
View
1
Download
0
Embed Size (px)
Citation preview
This brochure may be revised without prior notice. We apologize in advance for any inconvenience this may cause.
8-4, Asahi, YoshikawaSaitama 342-0008 Japan
WE17b-1607
Agent
Dimensions and Allowable Movements
Operating Conditions and Performance
0.1{1.0}
0{0}
40
20
0–10
60
Pressure[MPa]{kgf/c㎡}
Temp.[℃]
eco-ProductsSK-10
FLEXI-DRAINFlexible Drainage Connector
Feature
Outstanding FlexibilityOwing to the characteristic of the high quality rubber and bias reinforcement, a moderate length Flexi-Drain provides up to 50mm lateral displacement. This outstanding �exibility allows the Flexi-Drain to be the best choice in drainage and other low pressure system.
Underground ApplicationIncorporated with steel reinforcing rings enable Flexi-Drain buried underground up to 1.5 M. without deform or failure. Flexi-Drain eliminates additional protection which is required by ordinary rubber joints.
Easy InstallationFlexi-Drain insert type end connection �xed by stainless steel hose clamp reduces installation cost and time. Flexi-Drain can be installed in series to provide greater displacement for critical application.
Structure
40
50
65
80
100
125
150
200
350
350
400
400
450
450
500
550
48.6
60.5
76.3
89.1
114.3
139.8
165.2
216.3
50
50
75
75
100
100
110
135
10
10
10
10
10
10
10
10
0.75
0.9
1.3
1.6
2.5
3.0
4.0
5.7
10
10
10
10
10
10
10
10
100
100
100
100
100
100
100
100
Allowable displacement [mm]Dimension [mm] Mass [kg]φD Lateral displacement Elongation CompressionL
To be used in most of the drainage, sewerage, or low pressure system to compensate the di�erential settlement and pipe expansion.
Working Pressure : 1 Kgf/cm2 or belowWorking Temperature : -10oC to 60oCTesting Pressure : 3 Kgf/cm2 (Max.)Applicable Fluid : Water, Drainage, and Non-Corrosive Sewerage
Applications
Rubber Drainage Joint with Easy Installation(for Both Above and Under Ground)
● Use after con�rmation that the maximum operation pressure and maximum service temperature are within the operation range.
Nominal Dia. [mm]
● Please use within allowable displacement range ● As shown in chart are data of non-concurrent displacement, please make correction for concurrent displacements. For correction method, refer to “Attention for handling or “TOZEN HP”
● Standard joints are for gas pipe (SGP) and polyvinyl chloride pipe (VP, VU). Joints for steel and cast-iron pipe are available to be supplied.
● For each end, two �at bands ⑤ are attached.
No.
①②③
Parts MaterialInner Rubber
Outer Rubber
Reinforcing Cord
EPDM(SK10)EPDM(SK10)Nylon Tire Cord
No.
④⑤
Parts MaterialReinforcing Ring
Flat bandMild Steel
SUS
L
φD
❹ ❸ ❷ ❶ ❺