SpecificationsPower 1 x AA alkaline battery

Battery Life 3 years (replace to avoid leakage)

RF Frequency 433 or 868 MHz dip switch selectable

Wireless Range 30m (100 ft)

Supervision Check-in Supervision, Battery Low

IP Rating IP67

Operating Temperature 0 to 50 °C (32 to 122 °F)

Dimensions H x W x D

8.35 x 8.87 x 2.29 cm 3.29 x 3.49 x 0.90 in.

Compliance CE

Compatibility EVO192 and EVOHD all versionsMG5000 and MG5050 (V4.88 and higher)MG5050 EN (V6.94 and higher)SP5500, SP6000, SP7000 (V6.94 and higher) SP4000 and SP65 (V5.28 and higher)RTX3 (V5.50 and higher)

PARADOX.COM

Features}Two-way wireless water detector

}Tamper on bottom of main unit to notify of unintended movement (fix-mounting required)

}433 / 868 MHz selectable dip switch

}Blue LED indicator and Piezo

}3-year battery life

}Any pair of pins in contact with water triggers detection

}Can be programmed to shutoff electric water valve using a PGM

}Firmware upgradeable

}Floor bracket with double-sided tape, no drilling required (included)

}ES1 Extension Sensor (optional)

}ES1 plug connection and wire cut both supervised

DescriptionThe WD1 is a two-way wireless water detector designed to trigger an alarm upon contact with water, minimizing the risk of severe water damage from leaks or floods while you are home or away. Being a two-way device provides an extra level of security and ensures communication to the panel, especially during detection, is received and acknowledged by your system.

The main unit is designed to operate fixed-mounted to a surface (by a center screw), or free-standing, and has a built-in piezo and LED. The optional ‘Extension Sensor’ ES1 is a useful addition; it acts as an extension of the WD1 detection circuit and is completely waterproof and symmetric (dual-sided detection) with no active components. It allows you to add an additional detection area up to 2m away, and in situations where water submersion is possible, can be placed anywhere while the WD1 main unit is placed in an area safe to transmit the alarm.

ES1WD1 Floor Bracket

WD1Water Detector

TWD1-G2K rev.00 - Printed in Canada 03/2019.Specifications may change without prior notice. International patents may apply. Paradox is a trademark or registered trademark of Paradox Security Systems (Bahamas) Ltd. KEEPING

MY FAMILYSAFE

Dimensions

8.35 cm(3.29 in.)

3.70 cm(1.45 in.)

Front / BackFront Back Side Side

2.00 mCable

8.87 cm(3.49 in.)

2.29 cm(0.90 in.)

4.00 cm(1.57 in.)

0.60 cm(0.23 in.)

5.20 cm(2.05 in.)

Front Back Side

5.20 cm(2.05 in.)

0.04 cm(0.02 in.)

Water Detector - WD1 Floor Bracket (Included) Extension Sensor - ES1 (Optional)

Common Uses

PARADOX.COM

Under Sink / Washing Machine

Water Heater / Sump Pump

Paradox 2-Way PGM

Electric Water Valve ON/OFF